20 Most Recent 1998 GMC Safari - Page 3 Questions & Answers

it is probably your door lock actuators going out or need to be replaced.There are videos on youtube that show you how to do the job if you are willing to tackle the problem.Although you possibly need to test the wires at the point (doors) to see if you have power going to the actuators.using a test light will let you know if you have power going to the lock

• your battery light is on because your alternator is going out to to double check start the car and pull the negative battery cable off if the car dies then you need a new alternator that’s a really good way to check if the care douse no die then take your alternator to an AutoZone and have the Ambridge checked but that’s the only reason your batt light will come on is a bad alternator

what is the question or problems?

Check ignition pick up coil if it has a distributor if not check the crank position sensor.

can you hear a click sound. check for poor connection at starter and battery if good the starter is defect

Check for a blown fuse.

check for codes with a scanner

That engine uses a CPI fuel injection system. It quirks a minimum of 58 psi to start. As little as 1 psi will cause it not to start. Once it is running it requis less fuel pressure do to the poppet injectors being under vacuum. Check fuel pressure with a good gauge. If you see less that 58 psi replace the pump. I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

If the van was built with the PASS key security system, you can't start it without a chip for the system. The system reads the chip in your key. The sensor for the chip is in the lock cylinder that was damaged.If the key did not have a chip, you should be able to disconnect the switch from the lock cylinder and move the slide with a screwdriver. The switch is on the steering column near the floor.

Check out www.streetrodguys.com they have rear ac block kits for every vehicle

Need to put a Tech II or a scan tool to identify what is setting the code. Autozone does this for free.

put in a factory pump with updated wiring harness as a replacement on these always. check power and groun while its acting up to make sure its the pump

I assume your question is which way does it come out... remove the front grill, hood, headlights, radiator, ac condenser.... and everything else that looks like it's in the way of the engine coming out the front of the vehicle. Support the transmission from below with wooden blocks, remove the bolts connecting engine to transmission and using a proper engine hoist, slide the engine right out the front -- easiest with intake manifold removed first, short, tight chain so engine hoist is low down one engine.

You don't jump a running vehicleYou shouldn't jumping any of todaysvehicles,always charge the batteryYou did whatever to itNow you need professional help

It is the Ignition. If you put starting fluid in it, and it did not start, then you probably have no spark.

Check that you have spark to the spark plugs. If not, then check the vehicles' Ignition System, and repair as neccessary.

You need a transmission shop You don't need to ask here- we can't tellyou what to do- or see any leaks or damage

Sort of. The engine is attached to a sub-frame that can be lowered away from the body. I strongly suggest leaving this to a professional.