2001 Ford Mustang - Answered Questions & Fixed issues
Power window fuse location for
There is a 20 amp circuit breaker located in the fuse box in the inside of your vehicle. It's in the number 43 position (see picture below). I hope this helps you and good luck.
7/13/2021 10:32:13 PM •
2001 Ford...
•
Answered
on Jul 13, 2021
•
10,460 views
Whine noise
Does occur in certain conditions? Like when the Air Conditioning is on? Check the a/c compressor if so.
1/29/2018 9:14:46 PM •
2001 Ford...
•
Answered
on Jan 29, 2018
•
127 views
2001 mustang keyless entry not working properly what do I do
You did it like this ?
Programming -Keyless Entry Remote Transmitter
NOTE: All keyless entry remote transmitters (15K601) must be programmed at the same time.
NOTE: All previous transmitter identification codes (TIC's) will be erased when programming mode is entered.
NOTE: To program (or reprogram) the keyless entry remote transmitters into the generic electronic module (GEM)(14B204), perform the following steps.
- Turn the ignition from OFF to RUN eight times within 10 seconds, ending in RUN. If the GEM has successfully entered program mode, it will lock and unlock all the doors.
- NOTE: The first TIC must be entered within 7.5 seconds of entering the program mode and additional TICs must be entered within 7.5 seconds of the first TIC. The programming mode is exited whenever the timing constraints are not met. Press any button on a keyless entry remote transmitter, and the doors will lock and then unlock to confirm that each keyless entry remote transmitter has been programmed.
- If the door locks do not respond for any keyless entry remote transmitter, wait for several seconds and press the button again.
- Turn the ignition switch to the OFF position, or wait up to five minutes after step 1, to exit program mode. If a keyless entry remote transmitter has been programmed (or reprogrammed), the GEM will lock and unlock all the doors one last time.
1/15/2018 12:09:18 PM •
2001 Ford...
•
Answered
on Jan 15, 2018
•
473 views
I have an 01 Mustang v6 automatic with about 125k
Fuel or spark issues can cause this . Transmission lockup clutch can make a chugging sensation . When in overdrive lightly touch the brake while keeping a steady throttle and see if the chugging stops . Post back .
11/25/2017 3:20:49 PM •
2001 Ford...
•
Answered
on Nov 25, 2017
•
134 views
How do I clean the EGR passages on a 2001 v6 Mustang.
disconnect the egy tube ftom the intake manifold/throttle body. clean the upening on yhrottle body and yube with either carburator or brake cleaner and a wire brush. Pretty simple, really nothing to it.
11/20/2017 10:18:42 AM •
2001 Ford...
•
Answered
on Nov 20, 2017
•
156 views
Not finding what you are looking for?