20 Most Recent 2000 Ford Focus - Page 5 Questions & Answers


The engine temp will go up when it is loaded like a hill climb. Also the fan only is run when needed for the engine, it is computer controlled, so unless the engine is overheating at idle you are likely just not aware of how it is operated by the computer, the engine temp will be about 230F before the engine fan is turned on.. As far as the AC blower fan goes you need to pull the fan and see if it works when 12 volts is applied with a jumper. You can run an active system test with a factory scanner and it will test the fan operation.

2000 Ford Focus | Answered on Jun 07, 2016


This means one of the sensors or the air bag itself is not working, it requires special diagnostic readers to repair.

2000 Ford Focus | Answered on Jun 02, 2016


an airbag light, can mean a number of things. Your airbag will not deploy if a fault airbag light is on. It is dangerous, it has to be taken to a mechanic, to get it checked out. God-Bless! The airbag codes need to be checked to find the fault.

2000 Ford Focus | Answered on Jun 02, 2016


When you first turn the key on, no crank, if you listen close to gas tank, can you hear the fuel pump run for a few seconds? If not, check proper voltage and ground at the fuel pump connector, engine cranking.

I have to ask, how long since a tune-up?
Are there any applicable trouble codes?
Anything else missing? engine cranking do you have spark at the spark plugs and fuel injector pulse?

2000 Ford Focus | Answered on May 06, 2016


It could be a spark plug, plug wire, or a coil. Sometimes thay break down intermittently. If it needs a tuneup, that would be the first thing to do.

2000 Ford Focus | Answered on Apr 24, 2016


They are known to have broken wiring in the drivers door jam the wires break from the door being open and closing ,I think there s recall for the harnesses for the front doors I could be wrong but check the harnesses on the drivers door the wires break at the connector just pull back the rubber around the harness?

2000 Ford Focus | Answered on Mar 19, 2016


Not sure about the Ford Focus issue?? If your motorized bicycle has wire spokes, they should be adjustable. Just tightening the spokes will pull the rim to that side. The opposite when loosening them etc.
If your wheels are of the mag type like a car, then maybe a bike shop can straighten out the wobble without more damage.

2000 Ford Focus | Answered on Mar 18, 2016


remove the rear seat cusion, thare should be a cover under the cusion with 4 screws take these out and under should be the fuel pump.

2000 Ford Focus | Answered on Mar 09, 2016


My first suggestion is always recurring to a qualified mechanic.
In your particular case there is an issue with Focus fuel pump, and Ford guarantees free replacement in many countries, ask to your local dealer, to find out if you can have fuel pump replaced for free.
FORD FOCUS Recall - FUEL SYSTEM, GASOLINE:DELIVERY:FUEL PUMP
2000-02 focus spi fuel pump problems - Focaljet
fuel pump in a 2000 ford focus SE
If you wnat to DIY, instead, buy the haynes manual, and follow step by step illustrated guide. Fuel pump replacement is not a complex operation.

2000 Ford Focus | Answered on Mar 09, 2016


Willard, normally inside your automatic transmission. check the link below.

Ford Focus Shift Solenoid Repair P0750 P0753 P0972

2000 Ford Focus | Answered on Feb 19, 2016


Brake light behind the brake pedal is stuck. under the dash free the plunger the brake pedal pushes and oil it.
As to the cruse control that could be a lot of things.

Hope this helps mike

2000 Ford Focus | Answered on Feb 19, 2016


Check battery for voltage, terminal condition, fuses, try jump starting or swapping out battery...

2000 Ford Focus | Answered on Feb 10, 2016


Check your battery and your battery posts, charge your battery if necessary, check your charging system.

2000 Ford Focus | Answered on Feb 10, 2016


There is a front and back side of the cam gears. Some marks are dots by the gear tooth, some are notches cut out.

2000 Ford Focus | Answered on Feb 07, 2016


according to autodata belt replacement guide , there are no timing ,marks on the cam gears
it require special tools and a good knowledge of mechanics to do the job so I strongly recommend that you get a workshop manual before starting on the job
I could type it all for you but with only two fingers , I would be here until next week as the directions are involved and you will need diagrams to full understand the procedure
that is why I suggest a workshop manual
the procedure is not as you would expect as on other engine makes and need to carefully followed

2000 Ford Focus | Answered on Feb 07, 2016


The brake switch is probably mis-adjusted. If it does not activate when the brake pedal is depressed, the brake lights will not light and the gear shift release solenoid will not activate. That, or the wiring harness is not connected properly to the switch or is damaged.

2000 Ford Focus | Answered on Jan 22, 2016


Buy a new one, very cheap, and you can look it up on YouTube and it will explain all. Good luck.

2000 Ford Focus | Answered on Jan 03, 2016

Not finding what you are looking for?
2000 Ford Focus Logo

5,166 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2001 Ford Focus
2001 Ford Focus

2,580 Questions

2003 Ford Focus
2003 Ford Focus

2,002 Questions

2005 Ford Focus
2005 Ford Focus

1,196 Questions

2004 Ford Focus
2004 Ford Focus

881 Questions

2006 Ford Focus
2006 Ford Focus

825 Questions

Top Ford Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

gerry bissi

Level 3 Expert

4388 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Focus Ford

  • Focus Ford

Most Popular Question

answer question

  • Cars & Trucks
Loading...