20 Most Recent 2005 Pontiac GTO Questions & Answers

Anti-theft light lit ? Could need to reprogram . Battery Disconnect or Replacement Problems

Bro, in your address bar (google, bing, etc) just type in your vehicle specifics with wiring diagram at the end and you will get wiring diagrams for your Vette. Sounds like a nice project too. I'm always doing that stuff, and I use google, because google is your friend.

http://tinyurl.com/mud858k Terry

Here are the specs.

http://www2.partstrain.com/store/details/Pontiac/GTO/Haynes/Repair_Manual/2005/Base/8_Cyl_6-dot-0L/H1610360.html

go to www.aa1car.com get the topic and fix it. engine can leak valvesGod bless you

Find a local authorized GM radio repair station in your area, or write Doctor don's.com an email and describe issue, he may be able to help, he is really sharp on GM sound systems.

when parking put into neutral put on the hand brake and take your foot off the brake allowing the car to settle against the brake then put it into park, this should eliminate the sticking in park as the cars loading the brake not the transmission

All you can do is get under the car and see where the fluid is coming from. At lot of cars are having problems with the lines rotting. It is usually where a clamp is or where dirt and crud can get trapped against it and corrode through it. Please rate my answer so I am awarded points for it.

Front Floor Console Replacement Removal Procedure
1. Remove the console trim plate. 2. Remove the left console trim panel. . 3. Remove the right console trim panel. 4. Remove the floor console compartment.

5. If equipped with an automatic transmission, remove the 4?screws?(1), attaching the console?(2) to the shifter assembly?(3).

6. If equipped with a manual transmission, use a flat-bladed tool to disengage the retaining tabs?(1) attaching the manual transmission shifter boot assembly?(2) to the console. 7. Remove the manual transmission gear shifter knob, if necessary. 8. Remove the manual transmission shifter boot assembly?(2) from the shifter, if equipped.

9. Disconnect the console wiring connector?(1) from the inner console.

10. Remove the two nuts?(1) attaching the floor console?(3) to the vehicle floor. 11. Remove the two screws?(2) attaching the front of the console to the instrument panel assembly. 12. Remove the accessory power receptacle. 13. Lift the rear of the console upward and remove from the vehicle. 14. Remove the floor console armrest hinge, if necessary. 15. Remove the center console end panel.

16. Remove the screw?(2) attaching the floor console rear air duct?(3) to the floor console?(1). 17. Remove the floor console rear duct?(3) from the floor console?(1). 18. Remove the console storage bin, if necessary. 19. Remove the console lamp. 20. Remove the console compartment lamp switch.