20 Most Recent 1991 Nissan Sentra 2 Door Questions & Answers

Here's a youtube video on the 1993. I found some other years but not the 1991. https://www.youtube.com/watch?v=31xZMpesBXU Here's one thing I found: https://itstillruns.com/how-to-change-the-starter-on-nissan-cars-10364.html

Give it a full tune up and clean the throttle body.

This is just a general answer. There are 2 ways to tighten a power steering belt, 1, by adjusting the power steering pump OR 2 by adjusting a tensioner pulley. Inspect the belt system and see which one your vehicle uses. If the pump is adjustable, it will be mounted on one end by either a sliding bolt on a curved bracket like the alternator, or by an adjusting bolt. If your car has an adjusting pulley, check the routing of the belt. It will normally run from the front engine pulley over the adjusting pulley then over the power steering pump pulley. The adjusting (tensioner) pulley will have to be loosened, then either pulled to the tightening position by hand and retightened, or else there will be an adjusting bolt and nut which must be turned to tighten the belt before retightening the pulley. Sorry, I don't know your car that well so my answer is just generic. Good luck

Look at the Manuel and find out where the adjustment on the break cable is and tighten it acording to what the Manuel says should be pretty straight forward or google it

In your fuse box should be a large 1-2" square box inside the fuse box. Or under the dash board .

WEll, usually not a bushing, but there is often lots of wear at the pivot pin. Usually best to replace entire hinge, as teh tolerance goes off when the pin wears...

http://www.ehow.com/how_7605549_remove-700r4-transmission-governor.html http://www.courtesyparts.com/31894-gear-governor-sentra-b13-1991-1993-p-83503.html

At he air cleaner box/

Whaf Does cooked mean?

check that you have routed the cable correctly as cables do not work well with tight bends.

Is it manual or auto,need more info.

most ecu's are reset by a fault code reader as they have to be reprogrammed and the reader does that.

Car no start problem is sometimes very difficult to confirm. You try all the possible things, but still you get no fault and problem is still the same.--------
In that case, you need to check few things individually.
Check the spark,the battery,the crank, the fuel and other most possible parts. Click this link below for more details:-- http://howtobyme.blogspot.com/2011/10/car-troubleshooting-tips.html