20 Most Recent 2003 Mazda Protege - Page 8 Questions & Answers

0answers

How do you bleed cooling system on a 2003 Mazda Protege

Read full answer

Be the first to answer 6/10/2012 4:07:35 AM • 2003 Mazda... • Posted on Jun 10, 2012 • Be the first to answer

0answers

What is the firing order for a 2003 Mazda Protege LX 2.0 ltr motor

Read full answer

Be the first to answer 6/9/2012 4:05:43 AM • 2003 Mazda... • Posted on Jun 09, 2012 • Be the first to answer

0helpful

1answer

2003 protege runs with high idel in each gear. I

No. You are set by the gear ratio in the transmission and the final drive. The only way to change this would be to change the final drive ratio in the transmission, and there likely are no aftermarket solutions available to you.

Read full answer

6/6/2012 1:33:10 AM • 2003 Mazda... • Answered on Jun 06, 2012

0answers

How to remove starter 2003 mazda protege

Read full answer

Be the first to answer 5/29/2012 4:02:53 AM • 2003 Mazda... • Posted on May 29, 2012 • Be the first to answer

0answers

2003 mazdapseed protege 2.0 turbo studdering and jerking at 3500-4000

Read full answer

Be the first to answer 5/24/2012 1:44:33 PM • 2003 Mazda... • Posted on May 24, 2012 • Be the first to answer

0answers

Mazda protege Air conditioner compressor only works on low fan speed

Read full answer

Be the first to answer 5/21/2012 1:04:12 AM • 2003 Mazda... • Posted on May 21, 2012 • Be the first to answer

0answers

2003 mazda protege neutral safety switch

Read full answer

Be the first to answer 5/19/2012 4:52:12 PM • 2003 Mazda... • Posted on May 19, 2012 • Be the first to answer

0answers

Mazda protege 5 hard to get into 1st gear

Read full answer

Be the first to answer 5/5/2012 4:05:29 AM • 2003 Mazda... • Posted on May 05, 2012 • Be the first to answer

0answers

Shift lever will not shift out of park on 2003 Mazda protege

Read full answer

Be the first to answer 4/23/2012 4:06:11 AM • 2003 Mazda... • Posted on Apr 23, 2012 • Be the first to answer

0answers

Install new alternater belt

Read full answer

Be the first to answer 4/22/2012 2:51:49 PM • 2003 Mazda... • Posted on Apr 22, 2012 • Be the first to answer

0answers

2003 protege speedometer fuse location

Read full answer

Be the first to answer 4/20/2012 4:02:40 AM • 2003 Mazda... • Posted on Apr 20, 2012 • Be the first to answer

0helpful

1answer

My 03 mazda protoge is idling slowly after I changed the spark plugs

You can adjust the idle screw that is at the end of the accelerator cable to increase the idel speed.

Read full answer

4/6/2012 9:23:17 AM • 2003 Mazda... • Answered on Apr 06, 2012

0answers

2003 mazda protege gear shift light not working

Read full answer

Be the first to answer 3/11/2012 4:51:05 AM • 2003 Mazda... • Posted on Mar 11, 2012 • Be the first to answer

0answers

I have a 2003 mazdaspeed protege and whenever I

Read full answer

Be the first to answer 3/5/2012 6:47:31 PM • 2003 Mazda... • Posted on Mar 05, 2012 • Be the first to answer

0answers

I have good voltage, but when I stasrt the car it justs clicks. After a few tries it starts. Could it be bad starter, solenoid or ground?

Read full answer

Be the first to answer 3/5/2012 12:15:44 AM • 2003 Mazda... • Posted on Mar 05, 2012 • Be the first to answer

0answers

Where is the fuse for a mazda protege dx radio

Read full answer

Be the first to answer 3/3/2012 4:12:05 AM • 2003 Mazda... • Posted on Mar 03, 2012 • Be the first to answer

0helpful

2answers

How to change a thermostat in mazda protege 2003

The lower radiator hose follow it to the engine block You woll remove 2 bolt 12mm or 14mm. there you pull out the thermostat. when you install you need a new thermostat gasket.The thermostat has a air bleeder nipple that has to be up. When you fill the radiator and you start the vehicle the thermostat will open up when it is warmed and coolant will sink down there you fill the radiator up always keeping you eye on the temperature gauge. Also fill the resovoir.

Read full answer

2/28/2012 3:42:46 AM • 2003 Mazda... • Answered on Feb 28, 2012

0answers

03 mazda protege code P0660

Read full answer

Be the first to answer 2/21/2012 12:35:30 AM • 2003 Mazda... • Posted on Feb 21, 2012 • Be the first to answer

0helpful

1answer

Show layout of mazda protege

Try autozone.com for a free layout of the chassis wiring and Powerbox. Just register your vehicle for free and you can even print the results to keep for yourself.

Read full answer

2/18/2012 4:24:49 PM • 2003 Mazda... • Answered on Feb 18, 2012

0answers