20 Most Recent
2003 Mazda Protege - Page 5 Questions & Answers
I have a 2003 Mazda protege 5. check engine light no codes
Remove the wire from the negative terminal on the battery and wait a few minutes, then reconnect the wire. This will "reset" the computer and remove the check engine light. If the light comes back on, take it to a Mazda service center and let them read the code. They will be able to tell you what is wrong. Pepboys, Autozone....arent always the smartest cookies and are wrong more than they are right.
I have a 2002 protege a/c wont work on all blower
Replace fan switch in dash.Or may even just need connections cleaned with some wd/40. To replace switch you need to remove dash and knob's, Then you have a switch that has the wires from fan to connector. . If these are ok and clean you need to replace your blower motor, Best of luck to you.
.
2003 mazda protege p0455 code
Look at the gas tank filler cap. Make sure the seal in the cap is good. If it is cracked it may be leaking air into the system. Simply replacing the cap usually fixes this problem
Electrical problem
could be a parasitic drain. http://www.ehow.com/how-does_4924110_car-battery-keep-going-dead.html
Protege air only works on 3
I had the same problem with my 03 protege. It worked on speeds 3 and 1 for a while then only on 1 so I took it to the dealer I bought it from. It was the a/c control head which cost $100. Works great now.
Not finding what you are looking for?