1999 Mazda 626 - Answered Questions & Fixed issues
ABS and TRC lights come on
Hi,try disconecting the negative cable from your battery for a minute to resset the computer .....C1
10/5/2019 2:16:46 PM •
1999 Mazda 626
•
Answered
on Oct 05, 2019
•
510 views
Purge solenoid 99 mazda 626
The Purge valve is on fire wall it has color coded caps and should be marked purge valve look by the brake master cylinder.
9/7/2017 5:15:05 PM •
1999 Mazda 626
•
Answered
on Sep 07, 2017
•
187 views
My 2002 Mazda 626 is overheating! I have already
Have you confirmed the water pump is working? If the car is moving at 10-20 MPH you should have enough air going across the radiator to prevent overheating in a moderate climate at this time of year.
5/10/2017 4:31:38 AM •
1999 Mazda 626
•
Answered
on May 10, 2017
•
335 views
1999 Mazda 626
Not a good signed metal shaving mean your engine is getting ready to go and you might have do to a head job
9/11/2016 11:49:10 AM •
1999 Mazda 626
•
Answered
on Sep 11, 2016
•
59 views
2.5l. Where is the bleeder valve for the cooling system?
Check on top of thermostat housing, there could be a bleed screw on that. If not there locate two heater pipes that travel in the engine bay toward the dashboard. These lead to heater matrix inside the car. If you follow these with your hand the higher one may have like a plastic screw moulded into it. If its there loosen it ( but not right out. Cos you will drop it) also be extremely careful as this is very hot water! Leave it open until only water (coolant) comes out then tighten it up good and tight. Once might not be enough. It could also be somewhere on radiator body but high up. Low level bleed screws don't work as air always rises
12/26/2015 11:32:05 PM •
1999 Mazda 626
•
Answered
on Dec 26, 2015
•
239 views
Not finding what you are looking for?