20 Most Recent
1999 Mazda 626 - Page 5 Questions & Answers
Replace fuel pump step step
Lift the car, unbolt the gas tank, drop it down, unhook all the wires and hoses, slide the gas tank out from under the car, unbolt the sending unit from the tank (either has screws, bolts, or a lock ring). lift the sending unit with attached pump out of the tank. remove and replace pump. now install in reverse order. Good luck
Changing a battery on a Cobra 7777 remote control
The battery in the 7777 remote is a CR2032. If upon changing the battery the remote fails to work then you should stand next to the car and hold down both remote buttons for around 10 seconds to reactivate it. The remotes LED will flicker rapidly during this process. Keep holding both buttons until the LED stops flickering then release both buttons. The LED should now be on constant, press the larger of the two buttons and the remote should now be re-synced.Note: This procedure is not to program the remote to the alarm, but to re-synchronise it.
After replacing leaky rear lines and while
sounds like one of the bleeder nipples wasn't tightened properly. There's a cool little bleeder kit that has a blocker ball in it so it doesn't allow any air back into the brake line when you go pump the brake pedal until you tighten the nipple.
Cv joins - knocking
If they're a knockin, they won't last long. Time for an axle replacement. You can get re-built axles for this car, less expensive and easy to replace. You DON'T want them to break while you are driving!! DANGER!!
Firing order
123456 is the firing order replace spark plugs and fuel filter those can all cause rough and misfiring problems also replace air filter
Speed sensor
Try this site:http://www.engine-light-help.com/speed-sensor.html
Not finding what you are looking for?