20 Most Recent 1995 Mazda MPV - Page 4 Questions & Answers

Your cooling fan(the electric fan in front of the radiator) is either damaged or not spinning. Don't drive it, until you get it repaired, or you
will seriously damage the engine.Good luck.

turn it off and save fuel. Seriously,Where do you hear the vibration comig from on the vehicle

?antifreeze or watter ? inside car or out? if it is leaking inside chance are it is a heater core ..if out side passengers side it could be ac condensation could be inside too if drain is plugged and if it is water if it is watter and not antifreeze the drain is behind Eng lower firewall short black hose with flat end you can clean it with a pipe cleaner sort is the car loosing antifreeze

try primming the fuel filter with diesel fuel and starting it if it does not start do it again and again till it starts. heres a tip,after you prime the filter a few time an try to start it spray a small amount of starting fluid in to the carb(not alot just a small amount,one quick shot).Remember this is a diesel so dont keep spraying starting fluid in,you can either lock the engine or mushroom the glow plugs.

Drivers door usaully has a sticker for the different size tire use can use on factory rims. The rest depends on where you live and drive.

Probably pressed onto the PS pump shaft, you need a puller tool to remove and another to press onto new pump.

Don't know your engine size so pick the appropriate one:

MPV Models 2.6L ENGINE
Fig. 2: Alternator installation — 2.6L engine

1. Disconnect the negative battery cable.
2. Tag and disconnect the wire and connector from the alternator.
3. Remove the drive belt.
4. Remove the support mounting bolt and nut.
5. Remove the alternator assembly. To install:
   
6. Position the alternator assembly against the engine and install the support bolt.
7. Install the adjusting strap mounting bolt.
8. Install and adjust the alternator belt.
9. Tighten the support mounting bolt to 28–38 ft. lbs. (38–51 Nm), and the adjusting bolt to 14–18 ft. lbs. (19–25 Nm).
10. Connect all alternator terminals.
11. Connect the negative battery cable.

check drive pullies a/c wateh pump, power steering,alternator

look on ebay

big end or main bearing.

Hi!

Is the fan working? Have you checked the relay? Also check for any leaks.

if it's a knocking sound it could be worn internal compnents ie. rod bearings. if it's a ticking sound the valves may need adjustment.
either way a mechanic will have to hear the sound to properly identify it.

no need to do these

check your wires and end maybe they are in need of repair .

locate the starter relay and possibly the ignition relay on the fuse panel under the hood or under the dash and replace it.

Robert

I sprayed quick starter, added some fuel injection cleaner and deicing liquid in the gas tank. for the time being it is running but for how long ? I do not know.