20 Most Recent 1995 Mazda MPV Questions & Answers

1 Answer

WL Turbo 2500cc Diesel engine oil in the water

If you have an oil cooler, It has an internal leak.

1995 Mazda MPV | Answered on Jan 19, 2019

0 Answers

My 1995 Mazda MPV van, 3.0L w/ac and automatic

1995 Mazda MPV | Posted on May 07, 2017 | Be the first to answer

0 Answers

1995 mazda MPV van need a diagram

1995 Mazda MPV | Posted on Jan 11, 2017 | Be the first to answer

1 Answer

What happens if u cant get the rusty freeze plug out of or 1995 mazda mpv

if it is leaking you will burn up your engine eventually . most of us drill a hole in them and with a punch pry the old plugout .have seen some the simply drive new one in over the old plug putting the old one inside the block

1995 Mazda MPV | Answered on Aug 19, 2016

0 Answers

What happen when a freeze plug is rusted stuck and wont come out of a 1995 medza mpv?

1995 Mazda MPV | Posted on Aug 19, 2016 | Be the first to answer

2 Answers

The water in my mazda bongo wont circulate top hose gets very hot while bottom hose stays cold , heater wasnt working but now managed to get heater working after bleeding the system but bottom hose st

Check the radiator-it may have blockage. Take it off and turn upside down and flush from the bottom.
If the top hose gets hot, that means the thermostat is opening. The bottom hose should be at least warm, and quite warm if radiator flow is good.

1995 Mazda MPV | Answered on May 01, 2015

1 Answer

The engine cuts out and does not accelerate,

try mass air flow sensor

1995 Mazda MPV | Answered on Jan 17, 2015

1 Answer

Engine cuts out and does not accelerates

you will have both a throttle position sensor and a peddle position sensor both fitted to your throttle ,the cars ECU must pick up both sensors so it is not doing so you may need to change the throttle body.as you can not just change the sensors on there own.

1995 Mazda MPV | Answered on Jan 11, 2015

1 Answer

Glow plug warning light flashing

Probably need new ones

1995 Mazda MPV | Answered on Jul 02, 2014

0 Answers

Mazda bongo 2.5 wlt 1995 2wd

1995 Mazda MPV | Posted on May 01, 2014 | Be the first to answer

1 Answer

2.5 wlt tappet setting

The MPV did not come with the 2.5 but the 3.0 V6. It has hydraulic cam followers and they are non adjustable.

1995 Mazda MPV | Answered on May 01, 2014

1 Answer

No spark from spark plug coming off of dispenser?

ignition coil

1995 Mazda MPV | Answered on Apr 13, 2014

1 Answer

I have a 1995 mazda mpv with 76,000 miles. I just replaced radiator and thermastat but still gets hot after driving up hill. What's wrong with it?

IF you have a motor driven fan it will be connected by a viscous fan hub . replace the viscous fan hub as it is not working and pulling air through the radiator when you need it most. I imagine that the temperature will be higher than normal while sitting at lights . If it is an electronic fan the run fault codes and look for fan relays --fuses-- and temperature coolant sensor, problems.

1995 Mazda MPV | Answered on Feb 26, 2014

0 Answers

Turn signal wires (Yellow left and green right) also brake lights are seperate yellow (left) and green (right) on vehicle, trailer connector has one yellow and one green wire. Where do I connect the s

1995 Mazda MPV | Posted on Feb 15, 2014 | Be the first to answer

1 Answer

Why do water-tank explode

have you checked that the electric cooling fan is working ?? if so check the thirmostat by removing and placeing in boiling water and placeing a thirmomitor in the wather the stat should open at aprox 88- 92 deg, failing that have the head gasket checked

1995 Mazda MPV | Answered on Dec 30, 2013

1 Answer

Mpv wont turn left

defective rack and pinion, something wrong with either side causing it to bind up during a left turn... Get the front end off the ground and see if it turns left, if not start looking...

1995 Mazda MPV | Answered on Dec 28, 2013

0 Answers