20 Most Recent 2002 Ford SVT Focus - Page 3 Questions & Answers

depending on trans and engine mount type the mark my be on flywheel but generally most cars it is located on the belt pulley attached to crank rod, center bottom one on engine block. the timeing mark should be visable from top looking down. if you use a big ratchet to turn over the engine by hand and go slowly, you should see thhe marks pass as you do so.

The cooling fan is controlled by the PCM via a couple of relays. Try swapping the cooling fan relays and see if the fan starts to work. If that doesn't work than you will likely need a scan tool to determine if there is a fan request from the PCM. I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Because you have no wiring diagram, so you can proceed to do the required testing, to find out the answer

English please.

first i would contact ford dealershift to see if any recalls with this problem...The transmission on the 2002 Ford Focus has been having problems shifting gears,The linkage inside the transmission suffers from premature wear, causing difficulty in switching or shifting gears. The transmission bands that wrap around each gear to hold the gears in place are becoming loose, causing the gears to shift harshly. Both problems have been the biggest culprit when the Ford Focus transmission experiences problems shifting gears. The only correction for this shifting problems is to have the transmission replaced or rebuilt. Read more: http://www.ehow.com/list_7328764_2002-focus-transmission-problems.html#ixzz347AiEF2K

Unfortunately there is no free source for Ford V Serial Number codes as access is required to the original Ford factory database


Ford Main Dealer or a Radio Decoding Service only

Did you get in any type of crash with that door? I think it might be jammed or part of the locking mechanism was bent. You can bring it in, it shouldn't be too hard to fix. Elisa Jed ' http://www.bwattspanelandpaint.com.au

un plug one of the light connectors and check for power and verify ground with a 12v test light tool (available for cheap at the part store.) if there is 12v present, and a ground when switched to low beam, remove the bulb, inspect the filament. you will likely find it just has two burnt light bulbs

8 Things that Can Cause Your Car to Overheat.. > The coolant level is low. >You have a leak in the engine cooling system >The thermostat is bad. >The water pump is failing >Your cooling system has trapped air >The radiator cooling fan is not working properly. >The radiator core has become clogged. >You have a blown head gasket.