2004 Nissan Titan - Page 2 - Answered Questions & Fixed issues
Is replacing the Body Control Module on a 2004 Nissan Titan as easy as removing the old one and plugging in the new one?
The answer to your question is no, The BMC controlled directly by the BMC are.
1. Power door lock system
2. Remote keyless entry system
3. Power window system
4. Sunroof
5. Interior room lamp
6. Warning chime
7. Turn signal and hazard warning lamps
Configuration EKS00777
DESCRIPTION
U1000
CONFIGURATION has two functions as follows:
? READ CONFIGURATION is the function to confirm vehicle configuration of current BCM.
? WRITE CONFIGURATION is the function to write vehicle configuration on BCM.
CAUTION:
? When replacing BCM, you must perform WRITE CONFIGURATION with CONSULT-II.
? Complete the procedure of WRITE CONFIGURATION in order.
? If you set incorrect WRITE CONFIGURATION, incidents will occur.
? Configuration is different for each vehicle model. Confirm configuration of each vehicle model.
READ CONFIGURATION PROCEDURE
CAUTION:
If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be
detected in self-diagnosis depending on control unit which carries out CAN communication.
This came right out of the 2004 titan manual don't think it's the answer you wanted to hear.
3/31/2015 11:46:54 PM •
2004 Nissan...
•
Answered
on Mar 31, 2015
•
1,287 views
Can't get my truck to start
If the starter turns but not the engine several things could be going on. The most likely is the Bendix mechanism in the starter. The Bendix spins out and engages the flywheel when the starter turns and then a spring pulls the mechanism back to disengage. If it is inoperable you will get the symptoms you describe. Another possibility (and more likely) is a bad ground for the starter so that it does not get enough amps to spin fast enough to engage the Bendix. You can everything correct electrically and the ground will get you. I would have an electrical shop look at it.
1/23/2015 3:07:42 AM •
2004 Nissan...
•
Answered
on Jan 23, 2015
•
224 views
How to reset the safety on power windows
You will either have to replace the drivers master window switch or you have bad window motors. If you can still control the windows on the driver switch then the safety switch is bad and you need to replace the whole master switch. If the windows still can't be controlled by the front, then the motors may be bad.
1/23/2015 2:59:24 AM •
2004 Nissan...
•
Answered
on Jan 23, 2015
•
313 views
My Titan won't rev over 1500 rpm what's wrong?
Hello, number of things. Have you run a diagnostic test on your truck? It could
be throttle sensor, air flow sensor, electronic spark advance, extremely dirty
fuel filter, dirty air filter. fuel pump,
fuel ratio sensor, and they are many other components that can go wrong.
GB...stewbison
1/23/2015 2:54:23 AM •
2004 Nissan...
•
Answered
on Jan 23, 2015
•
2,211 views
Gear shift stuck
Something spilled into shifter binding mechanism. Clean with windex for best results.
8/24/2014 11:54:24 PM •
2004 Nissan...
•
Answered
on Aug 24, 2014
•
248 views
2004 nisan titan shiftre gets stuck in park at times
Start by checking if your brake lights work since the shift interlock and the brakes use the same fuse. If they don't you have a bad fuse. If the do then you might have either a bad shift interlock or a bad break switch.
8/18/2014 6:18:13 PM •
2004 Nissan...
•
Answered
on Aug 18, 2014
•
306 views
Truck will start but shuts off immediately
Primary and cheapest process of elimination checks for this type of
symptoms would be to check air filter and gas filter. Is the engine getting adequate air and fuel?
7/1/2014 3:24:02 AM •
2004 Nissan...
•
Answered
on Jul 01, 2014
•
62 views
Not finding what you are looking for?