Top 20
2004 Nissan Titan - Page 8 Questions & Answers
Code P0455 for nissan xterra 2002 v6
That code if for a leak in the evaporative emissions system. Check you fuel filler cap first. If it isn't on right it will cause this fault code. If that's not it, you'll need a mechanic to test the entire system for leaks.
Water dripping into cab on a 2004 nissan titan
Get under car and look for evaporator drain hose. (wear eye and face protection) . Use a long screwdriver and clean it out . Be careful cold water and debris will fall on you. That should solve the problem.
Oil leaking from around filter
The3 oil filter if over tighten it will leak around the seal. Replace the filter and hand tighten only if this is your problem
Oil is leaking from around the oil filter
The rubber O-ring from the previous oil filter most likely stuck to the engine when filter was replaced. Remove oil filter and ensure only 1 rubber O-ring is sealing the oil filter to the engine.
Check engine light came on then discovered the
Hi,
As the check engine light is ON, you need to take your vehicle to the nearest autozone . As the check engine light is ON, this confirms that there is an error stored in the memory of the car computer.Once you scan the car, you would get certain codes. Let me know the codes and i would be able to follow up from there. There is no point of wasting you time on speculations when scanning the car would most probably tell us the root cause of the problem. For more about check engine light, read :-
http://www.fixya.com/cars/r4008552-check_engine_light_being
If you have the scanner, you could also scan the codes with it without taking / towing the vehicle to autozone.
Let me know,if needed further assistance.
Hope i helped you.
Thanks for using ' Fixya ' and have a nice day!!
My drivers side air bag deployed and the Nissan
What kind of dealer can not locate spiral cable?
The name of that spiral cable is CLOCK SPRING ,
it's under steering wheel , connecting air bag at wheel to main harness.
I would recommend to change the dealer before your air bag shoot you in the face.
Shut off
If by that you mean that you truck shut off and you can't start it up then you must do some testing: first find out if you still have power in the battery - use a voltmeter to read at least 11 volts, if not, the battery is dead; if that happened while driving then the alternator is dead.
Next check that you have power at the key switch by turning in the first position and lighting up the interior lights.
Next check that when you turn the key the dash lights up - if it doesn't then you have a bad contact in the key (or wiring) or the fuses are burned.
Finally try to start the engine - if it turns then you must tow the truck to have the error codes read. Once you know them you can investigate further.
I am connecting a trailer towing harness to my
if you go to the parts store they make them ready to plug in you will have to just unplug the tail lights and plug the wire harness inplace of it then itll plug back into the original spot.
My 2004 nissan titan truck wont shift out of park
just a suggestion this may not be your problem but check by your brake pedal for a switch that will be built like the switch that turns out your refriderator lite this switch is a safety telling the shifter the brake is depressed and it is safe to shift out of nuetral, make sure the brake is fully depressing this switch good luck
How hard is it to replace a catalytic converter on
You will either need to buy the direct replacement which will cost a good amount of money (hundreds) or you can buy an aftermarket which you will have to cut out and weld in.
I recently bought an aftermarket catalytic converter for $100 and the muffler shop welded it (and a muffler) for $60.
My 2004 Nissan Titan 4x4 SE will crank, but will
Well first of all, who ever gave you the idea of using ether to start your Titan should be strung up to the rafters and shot with frozen paint balls. Using ether to try to start this vehicle can lead to the heads separating from the block. Do not tell the dealer that you did this!!!
Is the fuel pressure ok? Do you still have spark? Its possible that a cam position sensor is not responding/relaying a signal.
Not finding what you are looking for?