Top 20 2004 Nissan Titan - Page 7 Questions & Answers

What is the model number of your unit

you can push it back in, but it may most likely pop out again. there is a snap ring inside on the end of the shaft assembly. we have seen some issues with those, but we repalced the whole front diff, because they get damaged, from the axle just floating loose just like in your case.

Check the throttle position sensor. Pull any error codes from the computer and respond to those indications...Check your fuel evaporative system, often set to purge at off idle and if raw fuel is being purged, rather than fumes, you can have yoru condition. There is a vapor separator that fails and the evaporative recovery system gets liquid fuel...

check transfer case motor its not working

start relay goes bad.

hi, did you observe the arrow on the pump. fuel pumps fuel only one way. arrow must show from fuel tank going to engine. fuel filter is the same. gerry

If it is getting hot when you stop - it could be a bad fan motor..
If it gets hot while moving - it could be a bad thermostat or a sensor..
Dont allow it to get to hot or it will cause costly damage to the motor..

Good luck ;)

In that truck you can use a grade like regular[ 5-20] -[10-30] it wont hurt to change oil unless the manufactors call for it.

Hello... One way to fix this is to remove the unit from the vehicle and take the outside case apart. This will allow you to see what is holding the CD from being ejected....

From there all it should take is a simple inspection of the mechanism in order to figure out how to remove the CD.

Good Luck....

Hi there,

Well first of all you can try fiddle with the window switch. Push it on and off quickly. If the windows move slightly, the switch's connections are simply gummed up. Try squirting a tiny bit of rubbing alcohol under the switches to clean them. If further you have the same problem means there is some problem in the switch and you need to replace them use a screwdriver to pop out switch from door panel, remove plug (there is a tab that you'll have to gently rise without breaking on the plug/harness) plug in the replacement and snap it back into the panel.
Here is a video that helps you, follow the below link -

http://www.youtube.com/watch?v=XKbszdcMkK8

Good Luck!!

Thanks

Need to know what the light looks like or what it says.

Trucks are very light in the rear compared to cars. This is most likely a combination situation where your getting a little too much torque at the back wheels, the tire tread isn't brand new, and the slick road all combine to create the situation. You can reduce this somewhat by adding a couple of bags of sand to the back of the truck over the axle and by making sure you have good tread and properly inflated tires.

Check brake fuid level in resevoir.

this problem us most often caused by a failing battery

Check brake fluid level, add fluid from sealed container if needed.

Also check for leaking rear axle seals. Look for oil on the inside of rear wheels.

I am not sure how much it costs but I have a couple of good ideas for you.Call around a couple places and they will give a free estimate that should be pretty accurate.Also,buying a new one is the best thing you can do.I have seen many people that bought used or have it rebuilt,and I would say 80-90% of the time,the results are very disappointing as they do not last as long.Also,when you call the shops,tell them your problem and be sure they say transmission,unless you have the knowledge enough to know it is the transmission.It sounds most likely that it is though.If you have AAA,a AAA shop gives 10% discount on labor.Good luck! Greg

Several OBD Codes about EVAP System, if you can tell us exactly what code in there, could send specific details about clues or solutions about this problem.

Keep in touch.

If the right turn signal works on the truck then you didn't blow a fuse. Try spreading the prongs inside the receptical to see if that makes the signal work. If it works then you will have to replace it in the near future. If that doesn't work the replace the wire that runs from the receptical to the truck. Hope this helps.

take the panel off 4 screws or so just on cd player & over heater control . remove cd player , cover screw's , wire harness ... cd 's probably stuck . remove all cd's put everything back together install cd's again . took me 6month's to figure out my girlfriend did in less than hour with wout breaking a nail!!!!!! lol gd luck .

See this website, lots of great info.

http://www.titantalk.com/forums/titan-performance-modifications/96655-replacing-third-brake-light-bulbs.html