Top 20 1997 Nissan 200SX Questions & Answers

you need to bleed your master cylinder also. you are going to need help pumping on the brakes. and you can bleed your brakes on the master cylinder lines just you bleed your brakes.

Turbo is not boosting

You need the door keys to shut the alarm off ,drivers side door put keys in and turn.

Check engine light on? Report codes. Are oil and coolant full? Top them off. Need tune up?

Have u already fixed the problem? disconnect the battery terminals

Yes!

You'll need to change the distributor, as the distributor shaft oil seal has gone bad. Without sufficient spark, you'll have no power. Don't forget a new cap/rotor.

There should be no oil in the distributor. Replace it. Oil will cause the spark to go anywhere. Most likely to a ground. The distributor base.

you will need a timing light to be able to adjust the distributor to make the timing 8 btdc otherwise you have no other way of checking it .

Buy a newer car?

1 mm

The tire size depends on which of the three models you have. The base model came with P175/70R13, the SE model came with P175/65R14, and the SE-R came with P195/55R15. Check the sticker on the drivers side door jamb and/or owners manual.

The base model is 175/70R13

you can adjust the tension by moving one or both bars. on one end it should sit in one of three notches. I have moved mine by hand but you may need a screwdriver or pry bar on some cars. also depending on the car, you may want to put something to protect your rear window. As some have alot of tension and may spring out, and hit the window. Just try different positions till you get your desired effect. And a last note sometimes the bars become bent or really weak from use. And may require to be replaced. If so then they can be ordered from the dealer.

go to where you purchased the aftermarket unit as most shops have professional fitters on the premises to fit it after purchase.

It sounds like the turn signal switch is falling apart.

if they are getting carcon build up then you have a weak ignition control module and the wrong spark plugs . with the wrong spark plugs it is running and working hard

its a air inlet temp sensor code if that sensor is good check the coolant temp sensor and trans temp sensors if there not close in temp it trips the code

What year, make, model and engine sizes there?