1993 Nissan Sentra 4 Door - Answered Questions & Fixed issues

input shaft bearing failure checking the magnet on the drain plug should chow metal bits

On this website you find fuse box diagram and description for Pontiac Boneville (1993) Pontiac Boneville 1993 fuse box diagram Auto Genius

suggest you check the distributor cap & especially the spark plug wire of the 3rd cylinder

buy a new one or remanufactured one

100 parts in a tranny.
bad governor unit in tail shaft.
low oil pressure.

see my tranny page.
http://carfix.stufftoread.com/

Their will be one but where i have no idea ,iam not a dealer only fitter ,now on the ford focus its hidden on the back of the fuse box ,you have to remove the fuse box to get at it

Check for power then check for resistance when a button is pushed. Each button has a different resistance

go on line and get a schematic . autozone can interpret it for you.

connection at batttery or replace starter

You have a vacuum leak therefore your car is running rich

Wonder if it has a safety switch that requires engine pulses. Had a similar problem with my lpg car was wrong mixture would take like twenty attempts to start the car.

In most cases, the reason why a gas gauge might stop working is because the sending unit located insider the fuel tank may have worn out. In some cases, this may require you to replace the fuel pump as well, because a lot of times they come with the fuel level sending unit attached. Otherwise, if your car is indeed fuel-injected and you are planning on dropping the fuel tank and changing the sending unit, I would also recommend changing the fuel pump as well, for good measure. I hope this helps! :)

best way is place a mark with a marking pen the old one and then place the new one

Does the car still start? Do the warning lights and gauges turn on when the key is turned to on? I believe that is part of what the ignition relay serves. Is it located above the instrument panel fuse box? If so, there are 2 or 3 other relays there: an accessory relay, an ECCS relay, and possibly a fuel pump relay. If you hold a finger lightly on each relay when the clicking occurs, you should find the one clicking. It could be a faulty relay, or the wiring for the relay needs checked.

CHECK YOUR VACUUM LINES,RAISE HOOD AND SEE IF ANYTHING IS LOOSE.DO IT WHILE IT'S RUNNING,AND LISTEN FOR OUT OF PLACE SOUNDS.aLSO WHEN WAS THE LAST TIME THE AIR FILTER WAS REPLACED,CHECK THAT FIRST.

theres a diagrame on the car stereo.just follow the diagrame. cheers!

Replace The Idle Control Sencer

Hi Craig,here's a link to replacing your thermostat,easy to do.

Common problem with nissan, the retractor mechanism for the dseatbelt has burned out. Its located at the bottom of the door pillar next to your seat. Remove srews or pop cover off and youll see it on the bottom of door pillar. You can get one from your local salvege yard for around 10 to 25 dollars

Could be your belt is loose or replacing.Also with belt loose,turn pulley with hand to see if it turns freely,here's a link showing you how to replace the belts,first tighten pulley and see if noise stops.