20 Most Recent
1993 Nissan Quest - Page 9 Questions & Answers
2000 nissan quest wont stay idling
William, No idle issue could be caused by a few things, vacuum leaks, low fuel pressure, poorly tuned engine, dirty injectors, failing EGR valve, etc.etc. Have a good tech. scan for trouble codes, diagnose and estimate repair.
Vibration on acceleration
when some vheel missing weight , the vibration begins at 40-45 mph, now if begins at any moment of acceleration ,check inner drive shafts , no outer joints
2006. Wires disconnected from underhood fuse box panel. How do I determine which wire connects where?
Not quite sure what you mean, did you break a wire harness loom that keeps all the wires bundled together or did you break an actual plug connector?
If you broke a loom clip them use black electrical tape to wrap the wires back together. If you broke a plug, go to the dealer and buy the new plug or harness. the new plug will have mew wires already attached and all you'll have to do is match color, cut, splice, solder, heat shrink and plug back in.
If you have another problem for some reason or another that I haven't hit on then I'd suggest going to your local parts stor or dealership and buy the repair manual for your car, turn to the electricl schematic section and follow your color codes from there..
Good Luck
Nissan quest 04, which means the code C1130
This code means the ABS control module has detected a problem with the engine control module. Possible fuse/wiring/ecm/abs module/relay issue. Have code erased and monitor to see if it comes back. If code returns...... futher diagnostics will be required
2003 quest 650 oil pump replacement
Why do you want to? I have yet to see a bad pump, unless they have been run completely dry. Don't waste your time or money on a pump. Replace the engine. Low or no oil pressure is from the crankshaft bearings.
I have a Nissan quest and the head gasket is blown should I use blue devils seal
No it won't work. And if you keep driving it, the head and engine block will need lots of flattening before you can put a new gasket there that will hold. The head gasket, does not hold some pressure, it has to hold thousands of explosions per minute for years and years.
Let a specialist check the head and engine need flattening.
Sorry English is not my first language, so I hope flattening is the correct word.
Not finding what you are looking for?