20 Most Recent 1993 Nissan Quest - Page 2 Questions & Answers

Try this. It's a later model but shows you how to locate, remove and replace. http://autorepair.about.com/library/faqs/bl721g.htm Good luck

Here is a general description on retrieving codes. You will need to check online for the actual codes and their meanings. Systems built before 1996 will not show much compared to OBD2 systems built after 1996. Turn ignition key on. On Pathfinder, Pickup and Van models, proceed as follows:

1. 1. Turn diagnostic mode selector on ECU to ON position and wait until inspection lamps flash.
   2. Note number of flashes, then immediately turn diagnostic mode selector to Off position.

Nissan recommends replacement of the timing belt and water pump at 84 months or 105K miles whichever comes first. ALWAYS replace the water pump at the same time as the timing belt or you will be out the same amount of labor in 2-3 months when the pump goes bad after the timing belt replacement.

use slimjim with window up to grab rod from outside handle to latch

Ere is no safe way of repairing a seat belt mechanism. You'll have to replace them. If you're referring to the latch,age sure there is no dirt or debris stuck inside.

You have a serious short circuit in the wiring to the tail lights. Fuses protect the wiring in your vehicle from catching fire.You need to trace the tail light wiring from the fuse box to the tail lights to locate the fault/short circuit.A wiring diagram can help as it shows the colour code of the wires to the tail lights. This problem can be difficult to trace and you most likely need an auto electrician to fix this problem. It could mean installing a new wire to the tail lights as a quicker fix and bypass the fault..

If the fuse is OK, then probably the switch is at fault

your trans is going out you can add a couple caaps of brake fluid to get the gears to catch but sooner or later its going to go out

No fuse, but on the side between the door the panel you can take off and just unhook the wire(s) and then put the panel bak on. The only problem is that the light will stay lit on your drivers dash board. But it ststop the noise with no effect, Take 20 minutes top to do this.

I got te same problem. I could not solve the problem. Did you solve the problem? how?

there is probably something bent and not allowing the latch to connect easily. It may be possible to readjust the mechanism or door tracks. probably best to have apanel beater look at it

that is a misfire in a bad way. sounds to be your timing