How can I set ignition timing for a 1993 Nissan pickup 2.4l fuel injection. I have the timing lamp, but I don't know the right mark, it says 10 degrees BTDC. The pulley has 6 marks, which one is the right one?
the mark to the right of the pully will be 0 .. it will be like this. 8 6 4 2 0
Posted on Apr 21, 2009
need to know cap,and button positioning and firing order for my1993 2.4 pickup
firing order is 1-3-4-2 is what the book said good luck
Posted on Oct 12, 2012
93 nissan d21 4 cyl automatic trans wont shift into OD. rpms reach 4000 at 65 mph.. what is the problem?
well there are a few reasons that could cause this problem some of which are easy fix others are a major fix.
1)The throtle valve cable could be out of adjustment, for this to be corrected it is best to be taken to a transmission shop, or you could buy a Chilton or Haynes repair manual to see how to adjust it yourself.
2)The O.D. solenoid (which depending on the transmission in the truck) is either inside or on the outside of transmission, could have a bad wire going down to it, or have a bad connection to it, or it may not any power getting to it /// First Check All Fueses on vehicle then locate where solenoid is the check wires for power. The solenoid could also be plugged or bad depending on condition of trans and the ATF.
3)In side the transmission the is whats called a Over Drive Clutch Pack and the cluthes could be worn out or completely gone this happens quite often with older vehicles. If this happens to be the problem then the only possible fix would be what is called a OVER HAUL in which the transmission is removed from the vehicle, disassembled, all clutches and damaged parts in side are replaced, then transmission is or should be cleaned and then reassembled and then the transmission is reinstalled back into the vehicle.
So depending on where you live there might be a transmission shop that might diagnose the exact problem of your 93 nissan and give you a quote on fixing it. Some shops do this for free other do not. My shop does this for free. So I hope this helps you with your truck.
Posted on Feb 01, 2011
where is the fuel filter located on a 2 wheel drive, 1992 2.4L automatic Nissan D21 pickup?
it should be under the car close to the driver side door. if you can't see it trace it from the fuel tank it should be attached to the fuel line. if you have the repolacement in your hand you will know what you're looking for
Posted on Feb 28, 2010
timing marks for 1993 nissan d21 pickup 4x4
Here are the marks . Good luck and thanks for using FIX YA. http://www.2carpros.com/car_repair_information/tec_info/1993/nissan/pickup/1993_nissan_pickup_timing_belt_diagram_marks.htm
Posted on Feb 28, 2009
requesting valve clearances for a td23 hot or cold
On the intake 0.0008 or 0.0020 (it's in between these 2)
this is for the stem to guide clearance. (for the intake)
The Exhaust 0.0018 to 0.0030 stem to guide clearance.
Posted on Jul 14, 2008
need photos of alternator and starter wiring on 93 nissan 4wd - 4 cylinder truck yes please i disconnected and didnt label wires thought it would be faster it wasnt. its good lesson. the engine compartment is very tight and i cant see where the ground/positive? wires attach.
there are 4 wires go to alternator
2 white wires go to battery
1 black wire goes to ground
1 yellow/black goes to bulb check relay
starter has only two wires
the big one goes to the battery and the small one goes to ignition system. you can not mix the terminals because the size of the studs on the starter
Posted on Mar 07, 2010
where is the chassis number on a nissan patrol 1993
The vehicle chassis serial number is found on the vehicle identification plate on the right side of engine compartment by the hood hinge and also stamped on the right front frame rail, adjacent to the engine
Posted on Mar 12, 2010
how do you remove the ignition lock on a 1993 nissan pickup?
Check this procedure:
- Remove steering wheel, if necessary, steering column garnish, if equipped, upper and lower covers.
- Turn ignition key to ACC position
- Push down the stop key with a thin rod, pull out the ignition key cylinder.
- Reverse procedure to install. Make sure that the ignition key is at the ACC position.
Hope helps.
Posted on Aug 10, 2011
How do you replace the starter and where is it on a '93 2wd pickup?
I have a '95. It's behind the passenger side tire. Remove tire and rock guard if you have one--couple of screws--and you can easily access it. two bolts facing rear of car, two connections up front. Honestly it was the easiest replacement I've ever done. Just disconnect your battery first.
Posted on Jul 29, 2009
453 questions posted
Usually answered in minutes!
829 Questions
564 Questions
428 Questions
367 Questions
319 Questions