1998 Chevrolet K1500 - Answered Questions & Fixed issues
1998 chev K1500 5.0L engine,
you caused a huge vacuum leak
hoses not put back or done wrong.
recheck all work, all things touched for done wrong.
How do I replace the
I HAVE DONE THIS. NOT A PICNIC. GET A NEW SWITCH, SO YOU KNOW WHAT TO LOOK FOR. UNDER THE DASH, & AGAINST THE FIREWALL, THERE IS A FACTORY ROUND RETAINER CLIP THAT IS HARD TO REMOVE. WHEN THAT IS OFF, YOU CAN PULL OUT & PUSH UP & WIGGLE TO GET THE SWITCH OUT & UNPLUG IT. ONCE THE NEW SWITCH IS BACK IN PLACE, A HAIRPIN CLIP FROM THE HARDWARE STORE WILL HOLD THE SWITCH IN PLACE. I HOPE YOU HAVE SMALL HANDS. I DON'T.
My 1997 chevy z71 will
sounds like u r a temp sensor and idle air control valve away from replaceing a computer....hope it helps
How do i set timing on 1998 chevy truck 350 vortec
number 1 plug wire should be pointing towards the front drivers corner . drivers side piston order is 1-3-5-7 front to back .passengers side front to back is 2-4-6-8 then the firing order is 1-8-4-3-6-5-7-2 . if you pull the # 1 spark plug and put your finger in the hole /remover power wire while doing this at the dist.bump the engine when you feel a rush of air that's the compression stroke when the piston is at the top of it's compression stroke . pop the cap look to make sure the rotor is pointing at the # 1 piston roughly and place cap back on so the # 1 terminal is over the wire end of the rotor contact tip and work clockwise around with the firing order and hope this helps .if it still dont want to run then you may have jumped timing chain or stretched they will jump out of time and cause a headache.
How to replace inside door handle on passenger on 1998 chevy silv
Remove screw from inside door grab handle. Remove door panel by carefully prying out plastic clips. Drill or chisel off pop rivets holding the handle on. Pull handle out far enough to disconnect linkage and remove handle. Install new handle and secure to metal panel with new pop rivets or sheet metal screws. It may be easier to reconnect linkages by removing the metal panel also.
Not finding what you are looking for?