20 Most Recent 1992 Chevrolet Lumina Questions & Answers

Depending on the vehicle, there is probably a U shaped slide clip that holds the lock cylinder to the body of the vehicle. It simply slides onto the cylinder against the deck lid. It should have a lip on the opposite side of the U opening to grip in order to slide it off.

1992 Chevrolet... | Answered on Dec 15, 2017

could be the crank sensor

1992 Chevrolet... | Answered on Sep 30, 2017

You need to have your power steering looked at. You can make sure the power steering fluid is full, first.

1992 Chevrolet... | Answered on Aug 22, 2017

Could becaused by a few different thing's . Map sensor , idle air control valve , a vacuum leak . Having the vehicle's scan data viewed would probably pin point the problem . Do you know what scan data is ? Is what a professional tech uses to find problems .
084 Engine Mechanical Tests Scan Data for Vacuum Leak
007 Idle Speed Problems Scan Data for Idle These kind of test's are what seperate week end DIY'ER's from a professional tech.

1992 Chevrolet... | Answered on Jul 01, 2017

Try changing the fuel filter, water trapped in it can freeze. Its a 92 and probably time for a fuel pump. They don't like water either.(Meythonol Fuel) Always change fuel filter when adding antifreeze to fuel

1992 Chevrolet... | Answered on Jun 15, 2017

could be a dirty fuel inject problem
run the fault code first to check for cam/crank position sensor problems or other electronic faults
and go from there
a dealer charging $80.00/ hr is cheap as where i am it is $145.00 /hr

1992 Chevrolet... | Answered on Apr 16, 2017

you have a faulty door latch switch. it does not know that the door has locked check your door functions manually that will give you a clue which side

1992 Chevrolet... | Answered on Oct 02, 2016

the relay for the brake is not proper and the connection is not healthy so check the relay first which can rectify your problem

1992 Chevrolet... | Answered on Apr 04, 2016

If you can get under the van and using a flash light look up to the bottom side of the hood. You will see a lever hooked into a rectangular loop. take a pair of plyers and pull on the wire to open or take a piece of round metal and have someone puch down on hood and you can push the hook for the hood

1992 Chevrolet... | Answered on Feb 03, 2016

Hope this helps!

1992 Chevrolet... | Answered on Jan 07, 2016

Usually when you get at the turn switch, you can use a jumper wire to bypass the turn switch and make the turn signals dance. If they won't work with the jumper, the problem isn't the turn switch. Maybe a problem with flasher or wiring issue in steering column?

Did you check for voltage at the turn fuse? Goes hot with the key on. Use a test light to check for voltage.

1992 Chevrolet... | Answered on Jul 12, 2015

Not the best picture for location. If you have another flasher for comparison it will help.

1992 Chevrolet... | Answered on Jul 12, 2015

Unless you have seen the inside of the door this is a guessing game but it can be done by feel. Place the slim jim in the middle of the window between the wiper and the glass. Put it as far down as you can and slide it around until you feel the mechanism. From there it is gently pulling, sliding and caressing it until it pops. If you can see the manual lock on the inside then you can watch for the to jiggle and you know you are in the right spot.

1992 Chevrolet... | Answered on Jul 09, 2015

Not finding what you are looking for?
1992 Chevrolet Lumina Logo

609 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Chevrolet Experts


Level 3 Expert

85216 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Lumina Chevrolet

  • Lumina Chevrolet

Most Popular Question

car locks keep locking unlocking

  • Cars & Trucks