Top 20
1988 Nissan 200SX Questions & Answers
My 1998 200sx stopped accelerating while getting on freeway.
Could be the cable that actavates the throttle plate on the intake..
The cable comes from the gas pedel and pulls on the throttle plane in the intake manifold.. opening the plate to let air flow through to the engine. On the other side from the cable is a plastic sensor with wires attached to it this is the Throttle position sensor.. if this is disconnected or broken the computer cannot receive the single that you are pushing on the gas pedel.. very rare for the throttle position sensor to break completly.. best posibility broken cable.. open hood find cable connected to throttle body, have someone in car push pedel see if it moves. Good luck.
How do you set rear end alignment on a 1988 nissan
you need to buy an alignment rack, they cost a few thousand dollars, you will need a shop to install it in too. might be cheaper to just take it to an alignment shop and pay them 30 bucks to do it, as often as you are going to need an alignment kind of wasteful to buy the cow when you only need a glass of milk.
1988 Nissan 200sx: The speedometer, techometer, and odometer
This is a common problem. All of these work from a printed circuit board. With vibration and age they will eventually get a short in the board. No one repairs them just replace the instrument cluster. Requires removing the front of the dash to remove it.
Need wiring diagram
its a one banger you **** ****!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Nissan ca18det wont start
try looking near the bottom pulley or around the gearbox housing near to where it bolts to the engine
My Nissan xterra 2001 when
THE MOST COMMON CAUSE OF THIS KIND OF SEVERE HESITATION IS THE MASS AIRFLOW SENSOR (MAF), IT WILL NOT SET A CODE IN MOST CASES. SEE PHOTO OF TYPICAL SENSOR
Fuel pump check
fuel filter also if it has a pump in the tank you should keep at least a fourth of a tank of gas because the gas is what keeps the pump from over heating also check the fuel pump relay and the oil pressure switch because if the oil pressure is to low it stop the car from running to keep from blowing it up .
Not finding what you are looking for?