20 Most Recent 1988 Nissan 200SX - Page 5 Questions & Answers

You have not said what your problem is.

Once you have the computer scanned and have fixed the problem, you may be able to disconnect the battery and clear the code to turn the light off. Otherwise you will have to use the scanner again.

Is there power betting to the starter? Battery cables fail, so do batteries.

It is pretty straightforward.Raise and support the vehicle. Remove the tire and wheel assemblies. Remove the bolts from both ends of the upper suspension arm. Remove the suspension arm. Reverse procedure to install.You may have to pry the thing with a pry bar to get the outer end of the suspension arm separated from the steering knuckle/strut lower end.

Are you check in this link of Autozone.com ?

try this with the car at a stop turn on the a/c and put a box fan in frount of the car and see uif the a/c gets cold if it does then check the electric cooling fans they might not be running at the proper RPM we see the fans abbilty to move air drop as the fans get some age on them also if the air dams around the radiator and condensor are dammaged this can also cause poor a/c performance at low speeds, if wile sitting still all you have to do is raise the engine RPM to get the system working then add another 1/2 can of r134a by the way when you did all the work did you e-vack the system before you charged it? if not that is you problem you have mosture in the system and all you need to do is have the system e-vacked and recharged.

Hi,
Go to your nearest Nissan parts center/dealer in your country.
Bring the registration for the engine and model number. It will take 40 to 60 days when the parts will arrive. Pay some initial deposit for the parts needed.

Hope that helps you!

is it knocking?

If not, get a cheap oil pressure tester at Harbor Freight and see if the oil pump is making pressure. Should be around 35 psi.

figure out what model and year it is then search for a used wiper linkage or transmission for your car on eBay and at local junkyards, also now called recyclers. when you have located a serviceable used one, buy a new wiper motor at a car parts store, not a dealer. then buy a repair manual for a few bucks on eBay, find a free one to read at a library, or search for a video on youtube to find a video of someone replacing a wiper on a car like yours. most models and years are the same within a manufacturer so does not have to be your exact car. do not use a used wiper motor and give the linkage a good coat of chain grease before you install it in the car.

their is no adjustment as such but what i think you have done is to leave a couple of spacers out that go behind the pump fixings when you changed it or you bought the vehicle like it ,what i would do is to go to a scrapyard and see if you can find one then take the fittings from that one ,I do remember working on a nissan or datsun as i call them and on the back fittings is a round spacer that looks like a big fat washer and these go between the pump and the cylinder block which then brings it out into alignment .