20 Most Recent
1988 Nissan 200SX Questions & Answers
My 1998 200sx stopped accelerating while getting on freeway.
Could be the cable that actavates the throttle plate on the intake..
The cable comes from the gas pedel and pulls on the throttle plane in the intake manifold.. opening the plate to let air flow through to the engine. On the other side from the cable is a plastic sensor with wires attached to it this is the Throttle position sensor.. if this is disconnected or broken the computer cannot receive the single that you are pushing on the gas pedel.. very rare for the throttle position sensor to break completly.. best posibility broken cable.. open hood find cable connected to throttle body, have someone in car push pedel see if it moves. Good luck.
Nissan 200 sx s13
The way to check your coils is to start the car and unplug them one by one and see if the note changes, if you unplug one and the note dosnt change then thats the one thats fried.By swapping them around itl still be down a cylinder and will be hard to tell.But yes i bet it will be a coil as i have a nissan also and they do fail and makes it sound like a subaru and smell off petrol.I hope this helps.
P.S i love those S13 200sx, great shape.
How do you set rear end alignment on a 1988 nissan
you need to buy an alignment rack, they cost a few thousand dollars, you will need a shop to install it in too. might be cheaper to just take it to an alignment shop and pay them 30 bucks to do it, as often as you are going to need an alignment kind of wasteful to buy the cow when you only need a glass of milk.
Not finding what you are looking for?