20 Most Recent 1987 Nissan King Cab Questions & Answers

0helpful
1answer

Timing marks nissan

It is on the internet There are pictures-google the question There may be You Tube Video to watch
7/16/2014 3:43:16 AM • 1987 Nissan King... • Answered on Jul 16, 2014
0helpful
1answer

Bad fuel mileage

We all are. Its called obsurd gas prices! But really, get your oil changed and replace your air filter and possibly go all the way and pay for a tune up. You will see the increase in power performance and gas mileage.
8/28/2012 10:32:57 PM • 1987 Nissan King... • Answered on Aug 28, 2012
0helpful
1answer

Clutch failure, can't get it

You have to get the gearbox opened and check on the clutch plate and pressure plate. NO OTHER WAY TO SORT OUT THE PROBLEM
7/19/2011 5:55:18 AM • 1987 Nissan King... • Answered on Jul 19, 2011
0helpful
1answer

Need carb assistance, seems like choke is not

1. Check the "anti-diesel solenoid" fuel cut solenoid. The solenoid should click when it has a power and ground applied to it. Remove the pintle and put the solenoid back in. If the idle circuit it OK, the engine should idle. If it does, then there is a problem with the solenoid. If it still wont idle , the idle circuit in the carb. Could be clogged.
---------
start removing carb and refitting.clean the carb and readjust the choke and idle. ----------To get instructions to do this.Please click on the link below:--- http://technoanswers.blogspot.com/2011/06/choke-is-not-working-on-nissan-king-cab.html -------------------- This should help.thanks.Helpmech.
6/3/2011 12:17:07 AM • 1987 Nissan King... • Answered on Jun 03, 2011
0helpful
1answer

My timing belt snapped and I took it to a

The pistons will hit and bend the valves if the timing belt snaps because they are very close.The alternator does not connect to the timing belt, there is a separate belt that runs the alternator.
12/18/2010 3:58:36 PM • 1987 Nissan King... • Answered on Dec 18, 2010
0answers
0helpful
1answer

Wiring to the fuel pump is shorting out

The fusable link he is talking about is ussually located next to battery look for a connector or black tape.
4/14/2010 7:47:05 PM • 1987 Nissan King... • Answered on Apr 14, 2010
0helpful
3answers

Engine will start but when key released engine

your ignition is bad. you need to replace the component you stick the key in.
3/12/2010 10:15:16 AM • 1987 Nissan King... • Answered on Mar 12, 2010
0helpful
1answer

How do you change the thermostat in a 1987 Nissan

SHOULD BE TOP HOSE LEADING FROM RADIATOR TO ENGINE . I BELIEVE ITS 2 BOLTS TOO TAKE OUT AND YOUR IN. HOPE THIS HELPED!
2/19/2010 7:32:28 AM • 1987 Nissan King... • Answered on Feb 19, 2010
0helpful
2answers

Carpet is soaking wet .not a heater core leak .no

take the wiper off on the passenager side and remove the plastic under that and make sure the drain is not clog with anthing give these websites a try www.alldatadiy.com and www.autozone.com wish you the best of luck Michigan Man.
2/14/2010 3:07:48 AM • 1987 Nissan King... • Answered on Feb 14, 2010
0helpful
1answer

Trying to get starter back into a 98 nissan

Use and extension, good luck, nissan starters are a pain!
1/9/2010 11:38:47 PM • 1987 Nissan King... • Answered on Jan 09, 2010
0helpful
1answer

Is the Z24 (S) engine from 05/87 navara unleaded

unleaded
1/6/2010 9:48:38 AM • 1987 Nissan King... • Answered on Jan 06, 2010
0helpful
1answer

When driveing i feel like the car wants to go its

you may have worn front suspension components such as, steering ends, ball joints, anti roll bar bushings,control arm bushings shocks and wheel bearings
10/1/2009 3:38:07 AM • 1987 Nissan King... • Answered on Oct 01, 2009
0helpful
1answer

87 nissan king cab

firing order. 1-3-4-2.e mail your fax. no will send diagram.
8/17/2009 11:46:25 AM • 1987 Nissan King... • Answered on Aug 17, 2009
0helpful
1answer

Head stud torque

cyl head torqes.1st stage 29 nm. 2 nd stage 57-67 nm. 3rd stage slacken off 360 cegrees, 4th stage 29 nm. 5th stage 64-74 nm. intake and exhaust valve clearance .38 mm hot setting. hope it goes ok.
8/17/2009 11:39:49 AM • 1987 Nissan King... • Answered on Aug 17, 2009
0helpful
1answer

Head bolt torque settings for 720 nissan cab 2

dear friend-your torque setting on the 720 is the same as the L18 and is set at 85 - 90 nm.
7/23/2009 9:02:00 AM • 1987 Nissan King... • Answered on Jul 23, 2009
0helpful
1answer

Volt meter in s reading almost 16 volts

Your voltage regulator needs to be adjusted to 14.5 volts or if it won't adjust you need to replace the regulator. If you have a bad ground it could make the alternator see the wrong voltage and cause it to go to full charge. If it haas a built in regulator you can buy it at an alternator shop and replace it it is help in place by screws. It would be helpful if you tell us what year and make of car. Some put out as much as 26 volts. so more input is better, also please rate this if you need more help.
7/15/2009 6:17:27 PM • 1987 Nissan King... • Answered on Jul 15, 2009
0helpful
1answer

87 nissan quit code 24 and 31 shows - would it be the computer that needs to be replaced?

1987 nissan showed code 24 and 31
also made dashboard lights go haywire
PROBLEM solved by self -- DISTRIBUTOR
5/25/2009 4:25:29 AM • 1987 Nissan King... • Answered on May 25, 2009
0helpful
1answer

Belts

the belt might be loose or it is too worn . replace the belt . if that dont work then its your alternator. replace alternator. good luck!!!
6/29/2008 1:59:05 PM • 1987 Nissan King... • Answered on Jun 29, 2008
Not finding what you are looking for?
Cars & Trucks Logo

Popular Tags

32 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Nissan Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

King Cab Nissan

  • King Cab Nissan

Most Popular Question

need carb assistance seems like choke

  • Cars & Trucks
Loading...