Top 20 1989 Mercedes-Benz 190 Questions & Answers

Your timing is too far advanced. Loosen the distributor securement bolt and back it off a couple of degrees in timing. It isn't that it has too much compression for the starter, it's just firing way too soon to start and run.

Lambda is a measure of the air fuel ratio and the aim is to have a Lambda of 1, though usually the range of 0.9 to 1.1 is acceptable. A lambda of 1 equates to the ideal air fuel ratio of 14.7 and at 0.4 the mixture would be so weak or lean it is a miracle the engine runs at all. I suggest you begin by suspecting the device you are using to measure the lambda. I notice you mention fuel distributor and being able to adjust the fuel. It is clear your car is fitted with a continuous injection system, a comparatively crude system with little or no computer interference. Measuring the lambda is fairly inappropriate as the system was designed to be adjusted by CO content which from memory was 0.5 to 1.5, though it was difficult to persuade well-used models to perform well with a CO level less then 2.5. A CO level of 2.5 would put your lambda tester off the scale (rich). As you say everything has been done to the fuel system so you can warrant the fuel pressure is correct and the fuel distributor and injectors are correct for the car. What about the valve and ignition timing? Has the exhaust been checked for obstruction? I am wondering two things; firstly, are you confusing lambda and CO content and secondly are you sure you are adjusting the amount of fuel that is being injected and not merely adjusting the air screw. From memory the fuel adjustment uses a long allen key or screwdriver to reach the adjustment that is in a deep recess in the air cleaner/fuel regulator/fuel distributor. See repair manual for details.

Two types were used .On this engine ,but not both together. One was round wth 4 round contacts inside ,And one that is colured green, i think if i am right .This has two contacts .Both on the top of the block on the inlet side of the head at the back.Removal is just to unscrew to extract it, If your not sure and dont know get firther help .

It could be the fuel pump relay.i had similar thing with an mk2 astra that would cut out then in a short while start again.
Good luck!

No, Mercedes 1989 model does not have chip. We have made a key for E Class and even made a video for it...

FUEL IS LIKELY IT. THE CHEAPEST TRY IS THE FUEL PUMP RELAY. FUEL PRESSURE SHOULD BE CHECKED

You sure its a V6? The 190E 6cyl was an inline 6 and no I'm not aware of them having a chip. None of my 190E's or the 300E had a chip in the key. Not even my 92 S320

most of them are 60 liters

That will be the item that has the high tension leads going to the spark plugs. If you have to ask it may mean that you don't have one as the coils or attached directly on to the plugs and the cpu does the distributing

NonYour best to remove the injectors & mailthem away to be Ultra Sonically CleanedYou could have them cleaned at a repair shopwith special equipmentAdding something to fuel tank, is too diluted to do anything but take your money

where is the transmission dipstick on a 2009 mercedes benz ml350

Good luck in your quest. If you don't have any luck you should be able to purchase one either from Haynes or possibly "faxonautoliterature.com". Hope this helps.

Yes the crankshaft positioning sensors could be be problem of the car, but i advice you to run a scan on the car for proper diagnosis.

The fusebox is located under the bonnet at the rear of the right/hand wing, the lid unclips and has the fuse listing on the underside. Please make sure the lid is replaced correctly, as water will soon cause relay and fuse problems.

Give me some more information about this problem. May be i can help.

what you hear is the horn relay which tells me that the fuse,wiring,horn pad,and relay is good.thus the horn itself is no good and needs replacing.

You can test coil by pulling coil wire and holding close to a grounded source while someone cranks the car (wear gloves strongly advised). The only way to test an alternator if car is not running, is to take alternator off & bring to a parts store to have them bench test it.

eBay, a book store, reference section of your local library. google it

I guess it means that you have to replace brake pads soon. :) Nothing major.

hundreds are available
which ones are needed?