20 Most Recent
2000 Chevrolet Malibu - Page 8 Questions & Answers
My girlfriend is telling me her car tends to
Check every battery connection. That's all the cables and connections to starter, alternator,engine block, etc. Have alternator checked it may be failing when it hits that particular RPM
Signal lights operate spuratically
I'm guessing from what you're saying is the turn signals don't always work when needed. The most likely cause is the multifunction switch.
Rear window on drivers side inoperable
start by checking your fuses making sure that you dont have any blown fuse.pull the door panel off so you can get to the wires to check for a power and a ground your switch should send a power meaning if it sends a power that at the motor you will have a ground and not any power until you hit the switch this is how most systems are.opposite would be the switch sends a ground wich means you will have power at the motor all the time .test all of this with your key on if you have your power and grounds replace the motor some sytems reverse the poarity meaning the wire that had power now switched to a ground and the ground switched to a power dont worry about that as long as you get one power and one ground there your motor will move.if you do not have power then you will have to go up and check the switch for power coming in and power going out.a simple tool to use is a test light you can pick them up alot of places pretty cheap
Fuel and temperature gauge both dropped while
Both gauges get power from the same circuit as the warning lights. So it could be a problem with the printed circuit board on the cluster or something in the wiring harness connector.
Not finding what you are looking for?