20 Most Recent
2003 Mercedes-Benz E-Class - Page 4 Questions & Answers
Washer resovoir
To remove the washer bottle you need to remove the right front wheel and the inner fender liner to access the washer bottle. Couple of 10mm nuts hold the bottle in place. Leak may be coming from filler neck rubber grommet as well and not the washer bottle.
5/3/2013 10:04:58 PM •
2003...
•
Answered
on May 03, 2013
Gear change vibration
These cars usually have a two piece drive shaft. There is a center bearing in the middle of the driveshaft for support and dampen vibration. It could also be the front rubber coupling where the transmission tailshaft and driveshaft meet. If both are fine try loosening the bolts on the rear transmission mount. Your mounts may be out of alignment allowing for unusual angles between the transmission and driveshaft. Good luck.
4/19/2013 12:23:40 AM •
2003...
•
Answered
on Apr 19, 2013
How to take back seat out of 2003 e500
to clips under seats one in each corner look like pices of thick wire push to one side and the base cusion will come up to remove the rear pice when the lower cusion is removed you can see three bolts 1 in the middle and 2 on the bottom corners when the bolts have been removed just lift the seat up and out hope this helps
3/24/2013 11:25:40 PM •
2003...
•
Answered
on Mar 24, 2013
How to take the seats out of a 2003 e500
four star bolts one in each corner of the seat there will be a plastic cover that slides out pull it forward and you can remove bolts do the back first then front before lifting out check to see if there is a wiring harness under the seat disconnect this also ps befor doing any of this disconnect the battery as if the seats have air bags etc it will show as a fault and will have to be reset hope this helps ivan
3/24/2013 11:22:59 PM •
2003...
•
Answered
on Mar 24, 2013
How to remove tire of my 2002 e 240 i tried but it got stuck cant remove it
do you mean the wheel stuck make sure its jacked up securely sit on the ground and kick it with the flats of your feet its just rusted on but make sure its securely jacked up and supported hope this helps ivan ps could hit it with a large hammer and a pice of wood use the wood to stop the wheel from getting damaged as you hit it
3/21/2013 5:49:58 PM •
2003...
•
Answered
on Mar 21, 2013
Reset without diag
please add more info what do you ant to reset the service indicator or is it a error coeproblem:
3/5/2013 10:04:16 AM •
2003...
•
Answered
on Mar 05, 2013
Not finding what you are looking for?