20 Most Recent 2001 Mercedes-Benz CLK-Class Questions & Answers

code p 0455 refers to evaporative emission (EVAP) system---large leak detected ====causes --hose connection/s---intake leak-----EVAP canister--EVAP canister purge valve the first place to check for a large leak is the filler cap properly installed and tightened

What about the ignition coils and spark leads?

Yes, the wheel bearing play is adjustable on your vehicle. It is not really hard to do, however it requires special tools (pullers) to remove the hub assembly cover without damaging things.

Remove the kick starter, check if the solenoid is okay and if not replace or service.

It will need to be scanned for fault codes. most likely and wheel speed sensor fault in this age of car.

wheel bearings should have no play at all The correct adjustment is no preload -no end float with the adjustment nut moved slightly to preload to fit the pin. It is happening on full lock ,check the full lock stop as the tyre may be hitting on the suspension or inner guard.

You need to have your ECU read, you can buy a ODB reader online for around 10bucks. Work with Bluetooth in sync with your phone. This way you can read error codes the ODB reader lists, look them up on the net and then take it from there. For me, i helped alot when i had issues with my engine management light going on after i replaces parts on the block. I need to check whether your car is using ODB or ODB2 port for the reader. Being i 2002 model im guess ODB, but have a look online. Do alot of work on cars, except i dont have much experience with automatic transmission car's as we don't drive them much in Europe, we want pure performance :)

I believe you do not remove the lens - rather you open the trunk and find the back of the lamp (you'll have to remove the panel in front of it) and remove and change the bulbs from inside the trunk.

Bad alternator means no battery charge. Run the battery down without a charging means no power and engine will die. Charge the battery and put a meter on it to see if it goes to 14 volts with engine running. If stays under 13 volts with engine running, replace the alternator.

You could remove fuse 25 (30amp) in the underhood fuse panel, but then no blower for AC, heat, or defrost. Need to replace blower regulator.

w208 PT1 MB part # I recommend using this OEM Fluid ONLY

Bad wiring? The wires that go between the car body and doors or in the center console - has someone spilled some coffee or drink in the center console? Is it just one window or several? (just one - I suspect door, several I suspect center console).

check the adjustment of the roof position switch /sensor . If it is activated then the switch/ sensor may be faulty.

You need to have the Freon checked in the A/C system. If that is ok check to see if there is power going to the compressor clutch. Low Freon will keep the system from working.

Have to find out why the fuse blowsWhat is wrong with that circuitThen you see if you have another problemcausing it to go into limp modeIf you look at a wiring diagram & had a factorymanua,l you could learn the vehicle strategyWithout both, your pretty much done & have topay a shop that won't educate you, if they evenhave a clue