20 Most Recent 1987 Buick Regal - Page 7 Questions & Answers


On the line going into the receiver dryer on the passenger side near the strut tower.

Buick Regal Cars... | Answered on Sep 09, 2016


Look in the owners manual for the fuse number.

Buick Regal Cars... | Answered on Sep 09, 2016


Usually only ford vehicles have an inertia shut off switch. Some bucks with anti theft will cut fuel off. It may need to be reset. As far as the ford type switch, I am pretty sure that the gm vehicles do not have one.

Buick Regal Cars... | Answered on Sep 04, 2016


no easy fix need to replace it --replacing it is the easy part getting everything out of the way is what is time consuming
03 Regal Gs Intake Gasket Replacement Yahoo Video Search Results

Buick Regal Cars... | Answered on Aug 31, 2016


I suggest to use Rust Bullet, it is a very good rust inhibitor with lots of good reviews. I have utilized it on my car and never had rust problems again.
You can check the below link for the automotive kit:
https://www.rustbullet.com/products/automotive.html

Good luck!

Rust Inhibitor Paint to stop rust and rust repair Stop Rust Permanatley...

Buick Regal Cars... | Answered on Aug 01, 2016


Do you mean the engine overheat warning? The power steering problem is most likely a defective steering rack, they always act up when hot due to internal seal leakage and fluid bypassing the seal.

Buick Regal Cars... | Answered on Jul 19, 2016


Wiggle the steering wheel back and forth while trying to remove the key, if that doesn't work try tapping the lock cylinder area with a hammer handle to free up any sticking lock cylinder pins.

Buick Regal Cars... | Answered on Jun 24, 2016


maybe tappets gone or a valve. no indicator lights sounds like an electrical fault check indicators/hazards fuse

Buick Regal Cars... | Answered on Apr 25, 2016


Spring may be broken. Try pulling the handle and at the same time pull up on the parking brake pedal. If it come up and releases, the spring is broken.

Buick Regal Cars... | Answered on Feb 15, 2016


Just pull up sharply and hard. Watch the roof when it pops out

Hope this helps Mike

Buick Regal Cars... | Answered on Feb 02, 2016


look under the dash on passenger side behind the glove box if i remember correctly. thats where gm put most ecms back then

hope this helps mike

Buick Regal Cars... | Answered on Feb 02, 2016


Talking about the Buick 231/3.8L - YouTube

? 7:28
https://www.youtube.com/watch?v=PBx2MgVy1V0
Dec 24, 2012 - Uploaded by WhoSaidTyler
I have been told they have a kit for that oil pump which consists of a spacer ring and larger oil pump .... Will ...

GM 3100 V6 rebuild (3.1 litre) - YouTube

? 1:49
https://www.youtube.com/watch?v=gsAMtuTbE5U
Mar 6, 2012 - Uploaded by MET-TECH LLC
New main bearings, rod bearings, camshaft bearings, piston rings, head gaskets, ... oil pan gasket, oil pump ...

GM 3.8L V6 Engine Piston Slap audio with Video - YouTube

? 3:22
https://www.youtube.com/watch?v=SGCg1KHi2NU
Oct 12, 2012 - Uploaded by seriousNoodle
It turned out to be a loose piston and unbalanced torque converter. ... Stats on Engine: 3.8L V6, GM VIN Code ...


Buick Regal Cars... | Answered on Dec 12, 2015


On a few cars/SUVs I've owned in the past they can lead the brake rotor to warp.

Buick Regal Cars... | Answered on Oct 19, 2015


You will really need a body manual for that specific vehicle to do type of work. You can buy it from GM. You can even buy it online from GM. // Really, if you try to guess at where the "pull" areas are (even if someone can tell you where they are), and/or what sections need a tool type puller... etc, etc, etc... you can do some serious damage to that _very_ fragile panel. It's the type of thing that can possibly be easy enough with the correct instructions and correct tools; while also being the type of thing you regret touching without such information. (In the "old days" you could have experimented on one in a junk yard, but those days are gone).

Buick Regal Cars... | Answered on Oct 15, 2015


The easiest route would be to replace the pcm with a used one. The quad driver circuits are inside the unit. Somebody trained at computer repair could do it, no problem. But just buy a used one for a few bucks, transfer your mem-cal packet (memory and calibration) into it, install it and you are ready to go again.

Before you take out your old one from under the dash passenger side, be sure and take off the negative battery cable from the battery. Never unplug or plug in any connections to the pcm when the battery is on line. Damage may result.

Buick Regal Cars... | Answered on Jul 06, 2015


what is the problem your having with the signals specifically. this info is helpful to help you.

Buick Regal Cars... | Answered on Jun 15, 2015

Not finding what you are looking for?
Cars & Trucks Logo

97 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1999 Buick Regal
1999 Buick Regal

753 Questions

1995 Buick Regal
1995 Buick Regal

619 Questions

1998 Buick Regal
1998 Buick Regal

483 Questions

2000 Buick Regal
2000 Buick Regal

406 Questions

2001 Buick Regal
2001 Buick Regal

413 Questions

Top Buick Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Regal Buick

  • Regal Buick

Most Popular Question

vacume hose diagram

  • Cars & Trucks
Loading...