20 Most Recent 2003 Oldsmobile Silhouette - Page 9 Questions & Answers


electronic control module ecm (not egr) different parts one controls pollution / the other controls the ignition control modle is under the coilpacks

2003 Oldsmobile... | Answered on Mar 08, 2010


Check the plug is completely plugged into the motor. Maybe a bad connection in the motor itself. Also check the switch, try wiggling it when turning on.

2003 Oldsmobile... | Answered on Mar 06, 2010


are you crossing wires at the rely or junction in fuse box?

2003 Oldsmobile... | Answered on Mar 06, 2010


Bulbs are bad, most bulbs burn out around the same time withing a day or two and both of your brake lights may have gone bad. Try with the simple and inspect the bulb and replace if you see any discoloration to the glass on the bulb. Good luck and than you for using Fixya.

2003 Oldsmobile... | Answered on Mar 06, 2010


That is not what this light means.When it is on it means that the computer has seen a problem with the emission or electrical part of the engine or transmission part of the system.You will have to get the code or codes read.Auto Zone will do this for nothing.Hope this helps.Good luck.

2003 Oldsmobile... | Answered on Feb 26, 2010


disconnect power and ground then reinstall cables

2003 Oldsmobile... | Answered on Feb 25, 2010


timing chains in this engine last the life of the car with no problems, so no don't replace it.

2003 Oldsmobile... | Answered on Feb 23, 2010


hi normally this refers to the sensor that is past the cat on the exhaust you sometimes have two sensors, one on the manifold connected to the engine, and one part the way down the exhaust after the catalytic converter, and the code will stay until it is cleared by a diagnostic meter..hope this helps

2003 Oldsmobile... | Answered on Feb 22, 2010


You may, but more likely not. Make sure that if you have a theftloc radio that you have the code before disconnecting the battery. I would disconnect the negative terminal. On a side note, if your only going to leave it for a month to 2, then it is really not necessary, the only drain on your battery will be the clock. I would be a little more concerned with the fuel, and for a couple months, it will still be ok. Much longer and a fuel stabilizer will be a good idea.

2003 Oldsmobile... | Answered on Feb 18, 2010


Passenger Side. Take off the wheel, reach straight in on the firewall side of the engine, about 6-8 inches past the harmonic balancer. should feel the plug and the bolt holding it into the side of the block. TAKE YOUR TIME. sometimes they break apart while removing and then you really have fun getting the rest of it out.

2003 Oldsmobile... | Answered on Feb 01, 2010


Please check the fan to ensure they are in good working condition.

A couple of time this happens and we blame it on the thermostat.

Also you can run a scan on the car.

Cheers.

Rate this solution.

2003 Oldsmobile... | Answered on Jan 13, 2010


it is eithor low or refrigerant or it has a bad switch

2003 Oldsmobile... | Answered on Jan 05, 2010


hi, look under your bonnet then towards the windscreen end of the bonnet you will see a small plastic resevoir that sits on top of a cylinder with four thin mettle pipes coming of it this is the brake fluid resevoir it will say on top of the lid that you undo use only brake fluid or something to that effect.

Make sure you find the correct resevoir it will be at the back just under the windscreen under the bonnet ok.

Let me know how you get on or if you need further assistance ok

Also if you have the owners manual then it will give you a picture in their of where the brake fluid top up resevoir is

2003 Oldsmobile... | Answered on Nov 19, 2009


you probably need a new thermostat, when they fail the new ones have a safety so they stay open to prevent overheating and cooking your motor.

2003 Oldsmobile... | Answered on Oct 31, 2009


low fluid.

Get the level checked and topped up, or have the fluid replaced.

2003 Oldsmobile... | Answered on Oct 23, 2009


If the car is automatic transmission its probably the inhibitor switch on the gearbox faulty.

2003 Oldsmobile... | Answered on Sep 19, 2009


Just replaced both front bearings on my 2000 olds silhouette, the traction control light / ABS light is still on. What do i do?

2003 Oldsmobile... | Answered on Sep 04, 2009


if u go to like a advance auto or auto zone ect... they can give u the firing order or get a haynes or chiltons repair book that will give u the firing order

2003 Oldsmobile... | Answered on Aug 15, 2009

Not finding what you are looking for?
2003 Oldsmobile Silhouette Logo

317 questions posted

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

Jonah Oneal

Level 3 Expert

14092 Answers

Marvin
Marvin

Level 3 Expert

85216 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Silhouette Oldsmobile

  • Silhouette Oldsmobile

Most Popular Question

check fan relay switches 2003 oldsmobile

  • Cars & Trucks
Loading...