I hear a clicking sound, parking lights and instrument panel lights flicker like its a short when the key is not in the ignition
Posted by jahobs67 on
you need to replace the light switch. It is shorting in the mechanism itself not the wiring. I had the same issue. Just another GM engineering blunder
Posted on Jun 09, 2009
how to remove a door panel to an oldsmobile aurora
Posted by superseth1... on
remove the two screws at the bottom of the door panel, and remove the plug around the door lever and remove the screw. Now lift up on the door panel. it needs to come up about an inch before you can pull it off, you will need to pull the insert out around the lever and pull the lever to get the door panel to clear.
Posted on Jul 18, 2010
CANT FIND WHERE THE SPEED SENSOR IS NO MY 1995 OLDSMOBILE AURORA
Posted by francesjon... on
hi , their is two different speed sensors on your vehicle one is the input speed sensor which is inside the transmission and the transmission will have to be removed to replace it the other one s the output speed sensor is located directly above the passenger side trans-axle shaft. your input sensor is the sensor which tells the transmission when to shift and the output speed sensor tells the speedometer what it should display and both those parts are fairly cheap they are around 15-25 dollars but just remember if your input speed sensor is bad it is gonna cost you a minimum of 1000 dollars to have a mechanic fix as the transmission needs to be removed hope this is what you needed
Posted on Jun 06, 2010
Can you stop a oil pan leak with bars engine oil leak fluild
Posted by pharrod on
yes and no, i wouldnt recomend it with aurora.. i had same leak from the oil pan and put in the bars and it stopped the leak for a couple weeks. after that it leaked the same as before. i would never use it again on any of my cars.. i had a friend put in new pan gasket and it stopped the leak... i believe this is pretty common with the aurora...is it 95?
Posted on Dec 27, 2008
Is there some way to test the ignition control module? I already called Napa, PepBoys, Autozone, and Kragen. Only Autozone does these kinda of tests, but they do not have the proper schematic. Is there another way to test if it is functioning or not?
Posted by geshra on
Idle / surging comes from the intake to throttle body rubber connection
Posted on Sep 09, 2009
Iv'e looked under the hood and all and there are no diagrams there i need the diagram for the water pump belt, <Northstar> engine if anyone can assist me with this would be great and also with a regualr GM puller will it take the pully off the cam shaft?
Posted on Dec 11, 2008
where is the idle air control valve located
ti is located at the side of the throttle body. It should have two screws holding it in place. its either black or silver. you can remove it and try cleaning the carbon off of it. also try cleaning the inside of your throttle body with break clean or carb cleaner.
Posted on Mar 14, 2010
I have a 1991 mazda rx7 and the battery keeps draining overnight. i thought the alternator was not charging it enough so i got a new one and replaced it but still the same thing and i have done this with two brand new batteries so im just not sure where else to look... and i know that no other lights or switches are left on so i am stuck please help... my 1995 oldsmobile aurora keep draining all the batteries that i put in the car....i thought it was the alternator so i bought a brand new one and the same problem still acures. I have a CD player and a system connected so i thought maybe the they weren't connected right so i disconnected them but the problem is still happening
Posted by ericfloes1... on
Connect a 12 volt DC test light between battery cable & post on positive terminal.(remove terminal) (inline) When that light is on, there is a draw. Radio memory, alarm/antitheft systems, etc will cause a draw, so make notes & pull them first. Light will be dull on low draw, bright on high draw. Watch light closely & start pulling fuses, when you see it dim down,or go off you;ve found a draw. If no change, put it back in & continue. I usually start with the suspected draw spots like listed above, and accessories fuses.(like a cigarette lighter stuck in.) If all else fails, I've had to remove all the fuses then start replacing one at a time, until light gets bright, to point me in direction of major draw. Don't be proud, if you don't think it's labeled well enough for you to remember where they all go, make your own drawing & notes. Keep me posted of your progress.
Posted on Apr 04, 2009
turn key, all interior lights come on (so I know it's not the battery) but my car will not start. I replaced the starter about 2 years ago. How can I find out what the problem is?
if the starter does not try to crank the engine when you turn the key, a pretty reliable trick is to lightly tap on the body of the starter a few times and then attempt to start the car. If it then starts, your starter is bad. hopefully you've got a warranty on the starter.
Posted on Sep 29, 2009
Cd player not functioning properly. when cd is inserted there is a clicking noise and then a coed appeares (e 2).Help!!
Posted by lngilbert1 on
the clicking noise is most likely the laser trying to focus on the disk, make sure the cd is clean and if thats not the case clean the cdrom player with a cd player cleaner
Posted on Sep 03, 2008
681 questions posted
Usually answered in minutes!
Step 2: Please assign your manual to a product: