20 Most Recent 2000 Dodge Neon - Page 9 Questions & Answers


Some times, all depends, sometimes it will not allow it to start but sometimes will, the reason for that is , the selector switch goes bad by getting the ****** gears messed up but the neutral safety part of the switch still operates,

so again the engine can start with a bad selector and some times not

2000 Dodge Neon | Answered on Aug 12, 2012


it means you have a bad fuse. check or have someone check your fuses to find the bad fuse and replace.

2000 Dodge Neon | Answered on Aug 09, 2012


Now I got it. You need to replace the low pressure (return) side hose going from the firewall to the compressor. Have the freon removed from your system first, if there is any left. You have to remove all the hose tie downs. remove the bolts or nuts connecting the hose to the firewall. Disconnect the hose from the back of the compressor. Reverse the procedure to complete.

2000 Dodge Neon | Answered on Aug 03, 2012


take the negative battery cable loose for 15 min.s and hook it back up this will reset some computer era's---make sure all other wires r connected in the area where the piece was installed

2000 Dodge Neon | Answered on Aug 01, 2012


Here is the description for the code. You need to check the sensor and the wiring back to the computer.

P0551 DODGE Description Power steering pressure (PSP) sensor is installed to the power steering high-pressure tube and detects a power steering load. This sensor is a potentiometer which transforms the power steering load into output voltage, and emits the voltage signal to the Powertrain Control Module (PCM). The PCM controls the electric throttle control actuator and adjusts the throttle valve opening angle to increase the engine speed and adjusts the idle speed for the increased load.
Read more: http://engine-codes.com/p0551_dodge.html#ixzz21xtT1DTz

2000 Dodge Neon | Answered on Jul 29, 2012


It is more likely bad connections on the back of the insterment panel. or bad soider joints on the pins on the cluster circut board.

2000 Dodge Neon | Answered on Jun 16, 2012


You are best suited to see a dealer service dept on this.

2000 Dodge Neon | Answered on Jun 12, 2012


You will have to get an ATSG service manual online, at
ATSG.Com or the same at the local Trans Parts Wholesaler,
the shops get their parts from.They should have what you need

I think your going to have to pull the unit & open it
up to do that,hope not. Not a job you will be able to do

2000 Dodge Neon | Answered on Jun 02, 2012


It should turn off after a few minutes, watch it and see that it does.

2000 Dodge Neon | Answered on May 25, 2012


First of all, check to see if the battery is charged completely. Then check to see if the alternator is bad.

2000 Dodge Neon | Answered on May 10, 2012

Not finding what you are looking for?
2000 Dodge Neon Logo

940 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2002 Dodge Neon
2002 Dodge Neon

839 Questions

2004 Dodge Neon
2004 Dodge Neon

733 Questions

2003 Dodge Neon
2003 Dodge Neon

727 Questions

2005 Dodge Neon
2005 Dodge Neon

688 Questions

2001 Dodge Neon
2001 Dodge Neon

534 Questions

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

85219 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Neon Dodge

  • Neon Dodge

Most Popular Question

2000 doge neon batry changed now trun

  • Cars & Trucks
Loading...