20 Most Recent 2000 Dodge Neon - Page 6 Questions & Answers

DId you check position of headlight switch? Turn it?

Drop the trans panfirst thing you see is the valve body there are several screws holding it on they may be torcks headed wiggle it some it should come right out

Check the neutral safety switch,if it is good,replace the ignition switch,if all the fuses are good,please vote,thank you

If you have a natural gas heater, make sure the gas is turned on. It won't work otherwise. I hope you warm up!-----------------------------------------Godiag M8 Wireless Auto Scanner

turn the key to the ON possition and turn it back off again... 4 times in a row. The final (4th) dance , leave the key in the ON possition... the lights on the dash will do their thing... and the temperary codes will be reset..(NOTE : do not START the car... just turn the key to the ON , not START)

I would think you have a problem with the wiper motor, it takes too much power, or your battery or charging system is at fault.

The fault code P1193 means EGR Drive Overcurrent. fix this problem, the car will start again._____________AD900

These two lights work together. The traction control uses the ABS to work. You most likely have a bad wheel speed sensor. Have it scaned with a scan tool under the ABS. Replace which ever sensor it says is open.

What you are hearing may be normal.There may be air pockets in the cooling system and you are hearing the coolant moving around in the system. Kind of like a coffee pot.As the thermostat opens at 195 degrees the coolant expands and contracts.Make sure the system is full of coolant.

check crankshaft sensor,

Is the fuel reaching the cylinder, is there compression in that hole? Any intake manifold vacuum leaks?

You don't give much info to deal with, but. Most cars have the controls for the movement of the air by Vacuum from the motor. Check under the hood for a vacuum hose that will come from the intake manifold to the firewall. Reconnect it and check again.If it's not it you might have a door inside the heater box that is stuck or just gone bad. Which means the removing the heater to repair.

replace ecm computer

You'll need as shop manual or repair book to get the test procedures for the ignition module-coil assembly.You need to know if you have power to the coil and a ground signal from the computer.