20 Most Recent 1996 Dodge Caravan - Page 5 Questions & Answers

PCM/ failure EEPROM write denied, and/or , No CCD messages from the TCM, or BCM. reprogram or get rebuilt PCM as the first place to start, and check all contact points, connections for no corrosion. clean all well!!!!!!!!!

it isnt hard to change out all you have are three screws and one plug to unplug to take the old one out and put in the new one.its under the hood on the passengers side on the firewall,,,its the only motor there

Could be the asd relay, the fuel pump relay, or the ignition module among other things.

wrong key ,or damage ignition switch, try to spray w40 into before insert the key, and use pressure air , it may work.

Pick up coil in the distributor

You have trashed a computer. Maybe all of them. Put a scanner on it and see which ones you can't read. These are dead.

Sounds like a battery problem. Check for loose connections/dirt at battery terminals. Or battery is dead. Will it jump start with cables?

Type: OBD P1698

If the pump is not making a noise, check your electrical connections on the pump. If the pump does make the normal sound to prime the system, you can check to see if the fuel lines are clogged before the filter. (This sounds similar to the step you are performing.) There is a relay that supplies power to the pump. It can usually be interchanged with another relay on the engine bay fuse panel (in most cars that I have owned). That could be the issue.

He must bleed the brake syatem if he did not there is air in the line.

enter this into you web browser and press return "crank sensor 1996 Dodge caravan 3.3l"

torque on what part but im very impressed you did give the year make model and motor size most don't even get close so please tell us what part

its located at the rad side of the motor near the bottom of the engine where the transmission bolts to the engine. its held in with 2 bolts.

are your blender doors closing to block off heat.

the switch is faulty.

The Air-conditioning needs to be re-gassed. Take the car to an Auto Mechanic to get the Air-Conditioning re-gassed. They might also need to check it for leaks to make sure the gas stays in.

i may be mistaken on if this applies to your model year but if the rear wiper does not work then check the fuse for rear wiper and replace if blown. make sure rear wiper switch is off and wiper is parked.if air bag light goes out after a few seconds then the rear wiper motor is bad causing fuse to blow. air bag module gets power for its fuse through wiper fuse.if wiper is not parked then fuse may blow when you turn yhe key on.you have two choices. replace wiper motor or remove tailgate door panel and unplug the motor