20 Most Recent
1994 Dodge Caravan - Page 3 Questions & Answers
No spark
Have you checked the auto shutdown relay ?
Outside sliding door handle is loose
There is 2 small nuts one on each side of the handle. You were correct in pulling the door panel as that is the way you can access them. They are difficult to see but they are there,
Diagram on the pcv valve
Its the L shaped plastic sitting in a rubber ring on one of your valve covers connected to Rubber tubing which runs to a throttle body port typically in the front of your carb looking thing. Its part of your vacuum diagram which a image for your specific vehicle is on the hood.
96 dodge caravan has drivetrain vibration at
Have the u-joints checked for serviceability. Check rear engine mount is in good condition check that the rear springs are still at the right height. You appear to have a harmonic vibration that is cause by worn u-joints or incorrect drive line operating angles from the angle between the rear of the gear box and the diff pinion having changed . Check the drive shaft for balance as sometimes the balance weight can throw off.
Replace motor mounts
You need to replace the Motor Mounts? These are very straight forward...Buy the 3 Mounts (might as well do the Trans mount while you are doing them all... You will notice a difference ImmediatelyUse a floor Jack, take weight slightly off the mount, remove the center bolt on the FORWARD one, then remove the 3 mount Bolts that hold it to the Frame, and reassemble.Do the Top Mount by the Camshaft the same wayTransmission mount is a little harder but you have to get under the car to do this one... Still need the Floor JackBut they are pretty straight forward, nothing Fancy to get it done...Estimated time to do ALL 3..... 50-75 minutes....
98 dodge caravan stalling when breaking
First thing I would check is the easiest fix that I encountered with my only chrysler car. remove the air intake tube at the point where the fuel goes in and the accelerator cable connects. With the car turned off, pull on the cable and you will see a round door type thing. Look to see if there is any black soot around the edges of it. If so, that is the problem, use some carb cleaner and a rag or a green plastic scrubber to clean it off. If you use something metal, you could permanently alter the way your car idles.
Not finding what you are looking for?