Where is the fuel pump shut off switch located on a 2004 Dodge Caravan?
Most of the modern fuel pumps are automatic and the switch is part of the pump, inside the tank. There is power to the fuel pump whenever the key is turned on.
Posted on May 27, 2009
1993 Dodge Dakota Windshield wipers stopped working suddenly. The motor still works, the wipers had lost their adjustment and were slamming the trim on the windshield last couple weeks. Is there a common bushing if stripped would stop them or if if one goes, will it bind up both from working? I was hoping to find a diagram of what the linkage looks like before popping the cowling off. thanks.
There are bushings that go bad. They are available from a parts store. Ask or look under the HELP! section. the cowl panel will need to come off. replace ALL of the bushings.
Posted on Oct 28, 2009
How do you get to the windshield wiper bushings in 93 Dodge Dakota ?
remove wiper arms and then you can raise the hood to remove screws that hold down the vent panel.
now carefully remove vent panel.
Posted on Jan 09, 2010
1993 dodge dakota fuse for headlights where is it
The fuse panel box is to the right of the glove box with the glove box
door opened or beneath the instrument panel (dashboard) on 1989-93
models. For 1994-96 Pick-ups, it is beneath the knee blocker panel.
For Headlights check Fuse 20Amp.
Posted on Dec 11, 2009
I need a firing order diagram for a 93 Dodge Dakota 3.9L V6
Hope this helps you.
Posted on Sep 17, 2010
need to replace blower motor on v6 93 dodge dakota where is it
Under the glove box
You can get to it fairly easily
The Blower Resistor in the firewall may be your
problem.
They rust out. Two screws,above the
A/C Valve
Posted on Dec 19, 2010
i need a serpentine belt diagram for a 1993 dodge dakota...3.9 V6...without A/C
Fig. Accessory serpentine belt routing-3.9L, 5.2L and 5.9L LDC gasoline engines IMAGE LINK
Hope helps (remember to rating this free amswer)/
Posted on Oct 01, 2011
re: 1993 Dodge Dakota, where might I find the fuel pump reset button or inertia switch? Thank you.
Posted on Nov 07, 2011
i want to see how the spark plugs hook up to the distributor
3.9L V6 engine firing order is 1-6-5-4-3-2, cylinders on the pass side front to back are 2-4-6, cylinders on the driver side front to back are 1-3-5.
Posted on May 14, 2012
how to replace it
It is located on the top of the bell housing at the rear of the engine towards the passenger side. Not fun to get to, but only has one 10mm head bolt holding it to the engine block and a rubber O-Ring that you will need to break loose. Make sure you get all of the old O-Ring out of the block and put a thin coat of lubricant on the new one when installing to help it go in.
Posted on Apr 18, 2016
834 questions posted
Usually answered in minutes!
1,021 Questions
870 Questions
712 Questions
723 Questions
618 Questions