20 Most Recent
2003 Buick LeSabre - Page 6 Questions & Answers
2003 buick lesabre custom head gasket replaced, now it won't run correctly
The squeel is probably a belt slipping.. means you need to tighten the belt.. The poor running.. To replace head gaskets you must remove everything on the top of the engine. I would look at everything i disconnected and make sure it is properly connected and all hoses and wires are in the right place. check your spark plug wires to make sure they are connected to the correct plugs. Spark plug wires best possibilty. Look for Vacuum leaks another good possibilty. Something you did is causing this problem check everything two more times. Check for loose ground wires for the fuel injectors. A good suggestion is to take pictures of the engine and all connectors and hoses before you dissemble. Then you can check the pics for reassembley. I always take the pics on every job i do.
When I hit a bump I bounce and bounce and bounce.
If the bouncing is in the front it is probably a strut.
If the bouncing is in the rear it is probably a shock
look for the shock to be oily indicating the shock is bad. But
usually if the car is bouncing two or three time after hitting a bump
the shock has either broken or come completely loose.
Why rearend leaks by both wheel areas 2003 lesabre?
this is a front wheel drive car there fore there is no rear end like a rear wheel drive. the fluid leak at the wheels is probably brake wheel cylinder/caliper or brake flex hose. check brake fluid level if its down then check for brake fluid leak if not then you will have to check the rear area for some other fluid leak.
Why is my front end pulling from sid to side
If this is driving fine straight but wants to pull to either side when you are turning either direction I would check the power steering pump. Check the fluid first for the power steering. Could be that simple
Howto repair left back window
Get a tool for removing the inner door panel. Determine which tool is used to remove door handle / armrest (screwdriver or Torx or hex head screw) and get that tool. Remove door handle, then door panel. Once that is removed, you can determine whether nylon tape needs to be replaced or if motor assembly has come loose and needs to be reattached or if the window is simply off its track (if it is, you should already know this because it will drop down by itself). A video is at
How To Install Replace Rear Power Window Regulator ...
If you want to have someone else repair the window, and if it has come off its track, use some clear packing tape (lengthwise) to secure the window to the door until you can get it repaired.
Not finding what you are looking for?