Top 20
2004 Volkswagen Passat - Page 5 Questions & Answers
Changing key batery
some can be and some cant !! if there is no visable place to change it or screws you can remove then you have one that needs to be replaced...had one replaced for my jeep last year..cost me around &100.00..........good luck and hope this helps and if so Please rate my post.
Rear door only opens with key
Remoce panel and check wiring. Car purchased used? Generally good indication that door has been replaced, so remove the panel and look to see if the wiring is hooked up, if it is then its most likely a motor replacememnt for the lock.
Volkswagon passat tdi engine problems
hello : my proplem is began after i drive my passat 5 kilometer the EPC yellow light is appear and i dont know what that mean . thanks foer your help .. my passat 2003 model petrol . 2000 cc .Rami SafranPALESTINE
Light has come circle with arrow
HelloThe engine
and transmission in this cars drive train are fully
electronically controlled by a computer called the PCM (Power Train
Control Module). Whenever a problem like this occurs the computer
stores a record of the problem (there are of course some exceptions
to this, like the fuel pump, engine coolant temperature sensor and
MAF sensor for instance) in the form of a fault code in its memory,
to read these fault codes you must have the systems memory scanned
with a special tool. Once the fault code(s) are read you then must
perform the appropriate diagnostic testing to find and resolve the
problem(s) DO NOT REPLACE ANY PARTS UNTIL A TRAINED TECHNICAIN
HAS DIAGNOSED THE PROBLEM TO AVOID SPEDING YOUR HARD EARNED MONEY ON
PARTS THAT MAY NOT CORRECT THE PROBLEM
How do u replace a 2004 vw passat radiator?
1. Disconnect battery 2. Drain radiator 3. remove any plastic and or fan shroud 4. remove electronic fans if equipped 5. remove upper and lower radiator hoses 6. remove any heater return hoses (if routed to radiator on your vehicle) as well as any transmission, oil, or power steering cooler lines that may run to radiator (if so equipped) 6. remove radiator from core support (there should be anywhere from 2-4 bolts that hole it in or a clamp type mounting system) 7.installation of new unit is reverse of removal
Wont start
are the injectors getting power and ground??
I have a 2004 VW Passat the engine light came on had it diagnosed the code is P0322 what does it mean and how is it fixed? Thanks
Symptoms- Engine Light ON (or Service Engine Soon Warning Light)- Lack/Loss of Power- The engine may be harder to start- The engine may stumble or stallPossible causes- Ignition/Distributor engine speed sensor harness circuit is open or shorted- Ignition/Distributor engine speed sensor poor electrical connection- Faulty Ignition/Distributor engine speed sensor- Faulty Crankshaft Position sensor- Low battery charge- Faulty Engine Control Module (ECM)When is the code detected?The P0322 code is triggered when the Engine Control Module (ECM) detects no signal.P0322 VOLKSWAGEN DescriptionIgnition failure sensor is used to check whether the spark ignition is occurred correctly or not and also used to tachometer drive. The sensor monitors the voltage difference between a resistance which is on the battery circuit for
ignition coil. When the ignition coil works properly, the electric current through the resistance is detected as voltage drop. This is confirmed for every ignition event with the crankshaft sensor and the camshaft sensor. If
ECM detects a malfunction, no ignition is possible, so the engine would not start. If there is no ignition signal for a predetermined cycle for one or two ignition coils, an
ignition coil circuit failure exists.
Driver side window not working. Can hear motor
the cable has proberbly snapped or worn its self off one or more of its runners get the door card off and have a look. if they are like the octavia's then they are riverted on to a sheet of metal that covers the inner workings of the door and you have to replace the hole lot to make things worse i think it is a main dealer only part.
Check engine light flashes and
A flashing ck eng light is an indication that your vehicle is burning way too much gas, enoigh to damage the catalytic converter. Is the shimmy rhythmic, like a constant repeated vibration that increases with acceleration? If so, have your ignition coils checked. You may have a defective one creating a misfire.
ABS light came on with
ASR - Acceleration Skid Control system.
When ASR warning light blinking the system is activated itself for car acceleration skid control.
For today's typical high-torque engines, traction control (ASR) can increase both comfort and safety, particularly when driving on slippery roads or surfaces offering differing levels of grip. Traction control permits smooth starting and acceleration through the full speed range without wheel-spin or fishtailing.
ASR only operates in conjunction with the electronic accelerator (E-gas) and uses components of the anti-lock braking system (ABS). If one wheel suddenly begins to rotate faster than the others (slip), ASR intervenes in the engine management system and reduces power until the wheel stops spinning.
The ASR system represents a further contribution to active safety as it maintains vehicle traction and directional stability throughout the acceleration phase at any speed. In addition, it reduces tyre wear. Activation of the ASR system is indicated by a flashing indicator lamp in the instrument cluster.
The ESP system means the Electronic Stability Program. If the ESP lights on the dashboard permanently the ESP system is faulty. You must access the ESP Electronic Control Unit (ECU) memory for pull out all DTC (Diagnostic Trouble Codes), using diagnostic equipment connected to the data link connector of the car. Then you will be full informed about bad pieces (e.g.: front right wheel abs sensor interrupted, ...). After bad pieces replacement you will be able to erase all faults memored by ESP ECU, in other words reset the ESP system and turn off the warning lamp on dashboard.
Not finding what you are looking for?