20 Most Recent 2004 Mitsubishi Endeavor - Page 7 Questions & Answers

1st jack up your car & remove the tire. The calipers are generally held on by 2 large allen head bolts. Personally I prefer to use an allen wrench that fits on a ratchet, but just an all steel allen wrench will work. You should be able to remove the calipers at this point. When re-installing the calipers you'll need to push in the caliper pistons (usually 2 per side of car) I've had good luck using about a 6" c-clamp to push the caliper pistons back in . I hope this helps.

Inside of your dash. Its a pain to get to and hard to explain. suggest go in youtube.com to what video of location.

Time for a New Clutch, Pressure Plate is too weak to hold

It sounds like a fuse, a loose wiring harness, or a bad ground connection.

I had the same problem with a hyndai. It ended up being a weak fuel pump, and a clogged filter. I changed both and never had any more problems with it. I hope this helps

If your radio works and you press mode .Does head unit recognize cd,s
It should display no cd,s cd error etc
The reason i ask this is to confirm that connection is ok to stacker
To eject PRESS AND HOLD eject button,insert credit card under cartridge,push fully in and move left/right untill eject
This will locate micro switch,so you can check discs

Bank two is the side with cylinder number 2. The even number cylinders should be on the side next to the radiator.

u might need a new starter

Check coil fuse -Could be a bad coil blowing the fuse

bad fuse