20 Most Recent
2004 Mitsubishi Endeavor - Page 3 Questions & Answers
How do you remove driver side door panel to replace broken interior door latch?
I just do them. Done to many. So this is generic. Look for plugs around the door handle, arm rest, and by the mirror. Pop them out, screws behind them. Screws can also be around the perimeter of the door panel. Also behind door reflectors. Once out lift up on the panel. If it doesn't go up, use a screw driver, start at the bottom and pop it off.
Blower motor location?
The blower motor is under the dash on the passenger side, remove the panels to see. Also replace the blower motor speed controller while you are there, it is mounted to the blower motor case.
What are the probable causes of DTC P0715?
P0715 Mitsubishi Input Turbine Speed Sensor Circuit Malfunction
- Input/Turbine Speed Sensor Circuit Malfunction - Wiring problem ! Check for 5 volts on the white an violet wire at the input speed sensor . Check for b+ voltage on the black / with white stripe . The last wire is low reference (ground inside the PCM ) Then check continuity Of same wires from PCM connector B-21, Pins 111 -white with violet stripe ,pin 113 brown . Check for open between PCM an the input speed sensor
Why rear wheels are locked up but front are not
the first place to check is then rear drive line "U" joints as fail on a regular basis and can be not allowing the shaft to turn properly
T check for diff , jack up one side and engage a gear
if the wheel spins then the diff is turning but if it makes a bad noise (all will rumble a t a low level in this position) the diff will be faulty
It is possible that a joint flange has come loose and the bolts are jamming on the back of the transfer case housing
Not finding what you are looking for?