20 Most Recent 1992 Mitsubishi Mirage - Page 7 Questions & Answers

check fuses

Are you sure it is the brakes?If the brakes were involved- then the work clearlywas a butcher job- at best

Constant 12V+ Red/Black Switched 12V+ Blue Ground Chassis Illumination Green/White Dimmer Black/Yellow Antenna Driver's Pillar Front Speakers 4" Dash Left Front (+) White/Blue Left Front (-) Black/Blue Right Front (+) White/Red Right Front (-) Black/Red Rear Speakers 6" x 9" Rear Deck Left Rear (+) Yellow/Blue Left Rear (-) Gray/Blue Right Rear (+) Yellow/Red Right Rear (-) Gray/Red

START THE CAR,OPEN HOOD,WITH ENGINE RUNNING USE WD-40 WITH THE RED STICK ON THE SPRAY BUTTON AND L I G H T L Y SPRAY IN SHORT BURSTS AROUND VACUUM LINE AREAS. WHEN YOU HEAR THE ENGINE CHANGE SOUNDS YOU HAVE FOUND THE AREA WITH A LEAK. DO NOT SPRAY THE WD-40 HEAVILY OR AROUND THE EXHAUST MANIFOLDS OR MUFFLER AREAS !!!!! HAVE A FIRE EXTINGUISHER AND PHONE HANDY IF YOU DO ! ! !!!!!!!!!!!!!!

Hello

The engine and the automatic transmission (transmission control is only for automatics, engine is still computer controlled no matter the transmission type) in this vehicle are computer controlled and in most cases when a fault occurs a fault code is stored in the memory of the computer control module. There are exception to this, such as the Mass Airflow Meter and fuel pressure problems. What must be done is to have all the basic testing done such as a scan of the system for fault codes as well as a check with a live data scanner tool for engine functions that are not within range of normal, a trained technician is required to know what is correct and what isn't, then based on careful diagnostics done from a factory repair manual the correct part is replaced or the wiring repaired or the computer replaced (known as the PCM), which is very rarely the problem. Other basic checks must be done as well such as mechanical problems with the engine as well as engine state of tune and mileage on the engine. The transmission can have mechanical issues as well such as no gear engagement at all or a failed pump or other pressure related problems.

My guess is something broke in the transmission or one of the drive axles.

Hey I have the exact same problem!...

I don't really know much about cars but I think disconnecting the horn is the way to go. I searched for "2000 mitsubishi mirage disconnect horn" and from what I could tell, the best thing to do is to remove the fuse for the horn...


http://wiki.answers.com/Q/Where_is_the_horn_fuse_on_a_2000_mitsibusi_mirage

I haven't tried it yet though but I will after work.

Chasis ???dont you mean chassis number --- well forget the one in the windscreen thats not acceptable for the annual inspection ...top of bulkhead/sorry firewall ,rear chassis frame behind the wheel ,front chassis behind the wheel ,in the boot /trunk ,but some american cars actually put them under the carpet behind the brake pedal.sorry i dont know where exactly we dont have these cars in spain

Usually in the fuse box near the battery.

Try code 4618. I hope this will work. Mitsubishi Performance Chips