20 Most Recent
2005 Volkswagen Jetta - Page 5 Questions & Answers
Remove rear door handle
pull out door handle while loosening the t20 screw that is located under the door jam plastic cover and small dot of tape. You will need a long t20 driver. Then you can remove the cover and unhook the bowden cable.
I replaced the front pads on a VW JETTA 2.5 and
As the brake pads wear, the brake pad wear sensor contained in the brake pad contacts the brake rotor. This causes the sensor to fail. When a pad wear sensor fails it opens the ground circuit of the pad wear warning light system causing the pad wear warning light to illuminate. Perform normal brake service to correct this condition and be sure to replace the brake pads with pads containing wear sensors. Once the brake pads and wear sensors are replaced, reset the brake pad warning system by turning the ignition switch to the "on" position. As long as continuity to ground exists through all the brake pad wear sensors the system should reset and the pad warning light in the dash will go out. If the pad warning light does not go out, a check of the pad warning circuit for an open circuit condition or poor ground must be performed.
Not finding what you are looking for?