20 Most Recent
2003 Pontiac Aztek - Page 6 Questions & Answers
How to find a speed sensor 2003 Aztek 3.4 L for dummies like me
1st if you open the hood of your Aztec. If you look to your left find your serpentine belt and follow it from front to back In order you have your water pump, next your Power steering pump. On the backside of your power steering pump you have two metal lines that run down behind the serpentine belt toward front passenger side tire. Best way to find it. pull tire off stick your pointer finger on either line follow that line as it goes toward the back of the motor or transfer case. Its the only Sensor with in a inch of those lines the 1st 12 inch in under the fender. If by chance your a rookie like me and you take on a Head gasket. Pay attention when assembling the steering pump back to its carriage.. Double and triple check that the lines don't pinch the cheap pig tail assembly that can create havoc on a couple things. 1st The speedometer wont work, 2 ND while driving done the road your transmission will not shift up with your speed and rpm. Again I'm a rookie but have commonsense...
How to reset key tumbler on a 2003 aztex
you cant you have to have a new key egnition put in and new keys programed couse I just had the same problem with my 2003 and it cast me about 425.00 and you only get 1 key with the new one if it is one with a code on it and mine was
Reset change oil light
Driver Information Center (DIC) Equipped
Step 1 of 5
Place the key in the ignition and then turn it to the On/ACC position with the engine off.
Step 2 of 5
Press the "mode" button on the DIC until "Oil Life Left/Hold Set to Reset" is displayed on the DIC screen.
Step 3 of 5
Press the "set" button and hold it down until "100%" is displayed on the DIC display screen.
Step 4 of 5
Wait until three brief chimes emit before turning the ignition key back to the off position.
Step 5 of 5
Start the engine of the Aztec to ensure the oil warning light ("Change Engine Oil") is no longer illuminated on the instrument panel. If it still is, repeat the procedure.
Non-DIC (Manual Change Oil Light)
Step 1 of 4
Insert the key into the ignition and turn it to the ON/ACC position with the engine off.
Step 2 of 4
Step on the accelerator pedal fully to the floor three times within five seconds.
Step 3 of 4
Turn the ignition key to the off position.
Step 4 of 4
Start the engine to ensure the oil warning light is no longer illuminated on the instrument panel. If it is,repeat the procedure.
Won't restart in Warm Weather
The first thing you need to do is run the system for fault codes, any Autozone will do this for free, ask for a OBD2 fault code test. If no codes show check the fuel pressure next time this start problem occurs.
2003 pontiac aztek park lights
Have you Checked the Bulbs themselved? Test the Sockets to ensure you are or are not getting power.Once that is determined we can help you further
Key stuck in ignition
on the bottom side of the steering column, there's a hole in the plastic about the size of a pencil. push a pencil or pen into the hole about 1/2 inch. you will feel a spring loaded pin push up easy against spring and turn key. will come right out. learned about this as i was tearing down steering column to get my key out. you will use this alot with a aztek.
Not finding what you are looking for?