20 Most Recent
1998 Oldsmobile Aurora - Page 5 Questions & Answers
Flashing headlights while the car is off
- Hi! try to check the wirings and also check the fuse for the headlights make sure it is not busted and if you will replace it make sure you use the right fuse amp.
- Also check the relay if you know how to replace a relay replace it.
- If you still needs further assistance don't hesitate to reply to this solution.
I’m happy to assist further over the phone at
https://www.6ya.com/expert/ramy_d9e7ebea3891f482
Low oil pressure
Do elevators smell different to midgets, why would you want to know this. Keep the oil in the engine between to oil lines on the dipstick or you wont properly lubricate the motor. Just because you have oil pressure doesn't always mean you have enough oil to properly lubricate all the bearings and cylinder walls.
Fuel pressure
fuel pressure should be 41 - 47 psi. with new fuel filter if fuel pressure very low make sure fuel filter not clogged.
1998 olds Aurora i have an oil leak, is it common
There are common places, you'll just have to look around to see where the leak is:
Around the oil filter and the housing
Around the oil pan and the pan gasket
The oil seal behind the damper pulley
Valve cover gaskets
These are the most common places, leaks can spring up anywhere.
Ignition when key is put
there is a way that you can bypass that all that you have to do is put a resister on the security wires that are white make sure that you have the right resister the way you do that is get a multi meter set it to ohms and match up your meter with the resister mind you that when you bypass the anti theft any one that has a key that fits your ignition will be able to start you car i have a remote start alarm on my car so when i arm my car you cannot start my car at all just something to think about
Idles at 1000 - 1200 rpms won't drop
high idle could be caused by air inlet duct collapsed loose or air filter element clogged,idle air control valve failed,idle air inlet passage or throttle bore is dirty full of deposit,mass air flow is dirty out of calibration,throttle plate throttle shaft or linkage is damaged or leaking.have vechicle code scan first before buying new parts.
Not finding what you are looking for?