20 Most Recent 1996 Mitsubishi Galant - Page 2 Questions & Answers

Usually a sign of a fuel problem, either too much or too little. Too much could be several problems including a clogged air filter, too little could be a weak fuel pump or other issue. A mechanic would check fuel pressure and air flow first.

get a Haynes manual for it

Legnum? Mitsubishi Legnum???? Mitsubishi Aspire Mitsubishi MX/MF Mitsubishi VRG Mitsubishi VRM (Hong Kong) 9 engines offered, day 1. and many trans, 4-speed automatic 5-speed manual 5-speed semi-automatic Mitsubishi F4A23-2; 4 Speed KM175, KM176, KM177 - F4A21-2 (176-5), K4A22-2 (175-5), F4A23-2 (177-8); ES Model 41TE F4A33-1 the truth is , you didnt post country, nor engine size. they match engine power to transmission (load rating) so>? forget that.. that is for later. IT DIED< so if the engine dont START the tranny issues are moot. so does it crank.???? if it cranks , it next needs spark got spark to all cylinders. that is if its not the Diesel engine, IS IT??

you have a positive wire touching a ground in the starter or on the starter's wiring harness it could be in the positive battery cable Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/tom_db3a51ff0ca57f20

Get the car towed to the nearest Mitsubishi dealer, for professional trouble-shooting and repair.

your transmition may have bands slipping or sticking soliniods , need to get it serviced at auto trans shop .

Have to check for codes & diagnose them to know what the problem is

You'll need to know if you are lacking fuel or spark to proceed with testing.

If you have the 2.4L engine, look at the attached pic and see if you can locate it on your engine.

Whats your question?

I don't know it could be dicey ,,iv'e seen wheels fall off due to worn bearing,,it all depends how bad it is ,,,

yes as long as u check out car b4. oil , fluids , tires . Make sure it is rd ready

HI
I suggest to try this sit (PDFTOWN.COM)

WITH MY BEST WISHES

The only proper way is to remove the gas tank completely and drain all the fuel out. The clean/dry out completely then re install it. Before putting fresh gas back into it.

P0400 Exhaust Gas Recirculation Flow---------autel ds780