20 Most Recent
1996 Mitsubishi Eclipse - Page 9 Questions & Answers
Neeed the codes for a 1996 eclipse thing where the
Try this website for resolving car problems by downloading a FREE
service manual for your vehicle. This is not an owners manual but a
factory mechcanic's manual.
http://ezinearticles.com/?Find-the-Free-Auto-Repair-Manual-You-Need-Online&id=92717
I'am trying to set the timing for a 96 mit.eclipse
you have to line up all 3 of your tjmjng marks.Is your engine single head or double overhead cams The marks have to line up.Firstyou have to remove the belt.Then remove harmonic balancer to get to the timing gear sprocket.It has a blade attached to it with 3 fins in between the fins is a little dip that is the crankshaft position.align that dip with the mark below the crankshaft position sensor.then you have to do the same with your camshafts.Then replace the belt and spin the the crankshaft clockwise to the aligment mark they should all stop on their marks.
My car's check engine light came on
Take the vehicle to Autozone and have it scanned for codes. Its usually free. then tell me about the code that was found and I'll get you threw it.
My card wont start.it's a mitsu 96 magna 4
Have you figured this problem out yet? I am think the relay fuse going to the starter is out, as I have a new battery. I am trying to look for a diagram for the relay fuses, that may be what you need also.
How can i tell if my turbo is bad on a 97 gst? are
You will feel a loss of power
Not too hard but time comsuming get a repair manual it will hep you.
If you have a boost guage your positive pressure boost will be lower than normal and the bearing may make a squealing sound if it's going bad.
Hello there My Pajero is havig a black smoke.Thou
Lost power and Black smoke?
You have a Failed MAP Sensor and / or the vacuum line is off or cracked.
The ECU thinks the engine is under full load and is getting all the fuel it can to the engine.
Hope this tip helps guide you to solve this problem.
r/
David
96 Eclipse 2.0 non-turbo Engine has a tapping
Most likely cause is a hydralic tappet. Mits are well know for top end noise. Note we are talking about a tapping or clicking sound not a knock. You can try using an engine flush product if the noise is getting bad and then changing your oil. Generally if the oil is not changed regularily eventually the tapping noise gets happens.
1996 mitsubishi eclipse doesn't start when turning
check for voltage at the small start wire on the starter when cranking the engine--you will need someone help. If there is no voltage you may have a bad neutral safety switch ,which is on the trany shifter.you have an automatic trans i assume.
If so try putting in neutral when cranking.
Not finding what you are looking for?