2001 Mercedes-Benz SL-Class - Answered Questions & Fixed issues

No you don't. Codes do not tell you to replace anything.You have OBD2 Codes indicting a possibleproblem with the sensorsTo have 4 sensors fail at once,not likelyYou should have that issue checked out bya repair shop

Call the local police department on non emergency number. they should help you out on opening the the front drive door

use a small needle or push pin to unclog the nozzle and to adjust if needed after unclogging.

belts loose on hydraulic pump/low on hydraulic fluid/sensor playing up ,specialised repair possibly ???best advice i can offer is to get dolled up to the nines and drive to a small local repair garage and start crying,95% of this working unless garage man is ***

The Auto anntena is driven by an electric motor tucked under the side skin inside the trunk. It is possible that some moisture leaked in and caused the system to blow, usually resulting in a blown fuse. Check the fuse box, the manual will identify the propler fuse position in the fusebox. If thats not the problem, than you'll have to look at the anntena drive motor a little closer.

needs fuel tank replacement-only fix for this problem-very involved job,recommend taking it to a shop to get done,not a DIY job

Question edited for clarity. Question moved to make model category. https://fuse-box.info/mercedes-benz/mercedes-benz-cl-class-s-class-c216-w221-2006-2014-fuses-and-relay More here https://www.google.com/search?q=2007+Mercedes+Benz+SL550+fuse+box+diagram ..

hmm... as i remember u have to STEP on the small pedal near the left wall and CLUTCH pedal?

Ask Mercedes on the internet this question.

These are cable driven there is a cable that goes into the rear differential its probably the sender unit thats gone on the diff side the 190e are the same type i think you can buy these and replace easy enough its just 1 hex nut that keeps it in place hope this helps ivan

Until you have the system scanned for fault codes all this is a guessing game.

Do you mean the ignition control module (ICM)?

That information is in the owners manual.

1st you need to open door, remove plastic trim on inside of door by the handle, there is a hole where a 25 torx screw is holding handle end cap, pull door handle in open position, slacken screw until end cap is loose, remove end cap & slide door handle to rear of door out comes the handle, check with torch for any broken parts

check earth points for wiper ,wiring issue or switch

keep with original tire diameter regardless of rims

Did you look on Ebay and Amazon ?

check the tank there's probably a leak

Replace coils, wires, caps and rotors then talk to me and well see.

It seems there's a problem with the internal rotary system that runs to the soft top. Check for unplugged/disconnected wires under the dashboard where the button or switch is. If you can't locate the problem, it's best to call a mechanic.