Top 20
2000 GMC Yukon Questions & Answers
2000 Yukon, tow/haul mode will not shut off, light stays on, what to do?
You will need to take it to a parts store like NAPA and see if they will read the tcm (transmission control module) for codes, if all else fails then take it to a transmission shop and ask if they can scan it for codes and check the functionality of the tow haul button if it is not functioning, it could be just a broken wire from flexing at the base of the shifter.
2000 yukon when head lights are on and the heater you turn hi beams and the heater turns to cold and blows in defrost mode and can't change the buttons u have to shut truck off to reset what's wrong
The first place to start with problems like this to try an reset the computers on the vehicle . Disconnect the battery cables an touch them together for five or ten min. Then if that doesn't work you need to have the vehicle checked out , which means having a factory or equivalent scan tool check for codes in the BCM !
The body control module (BCM) is capable of controlling multiple body functions. Components directly connected to the BCM are controlled by the BCM's outputs. The BCM controls the outputs based on input information that it obtains from the sensors and the switches that are directly connected to it. The BCM can also borrow information from other vehicle systems connected to the Class 2 serial data link. The BCM evaluates this information and controls certain body systems by commanding an output ON or OFF.
The BCM is also capable of commanding other vehicle systems to control functions that are not directly wired and/or controlled by the BCM. The BCM accomplishes this task by sending specific messages on the Class 2 serial data link. The vehicle system capable of performing such function will respond to the BCM message.
The BCM controls the following functions:
?€¢
Audible Warnings
?€¢
Indicator Warnings
?€¢
Interior Lighting
?€¢
Exterior Lighting.
?€¢
Power Door LOCK/UNLOCK
?€¢
Remote Keyless Entry
?€¢
Passlock Theft Deterrent
?€¢
Content Theft Deterrent
FUEL GAUGE READS FULL WHEN EMPTY AND EMPTY WHEN FULL
Did this get replaced recently?
Fuel level senders typically work by changing the resistance (and therefore current) depending on the fuel level determined by the position of the float mechanism in the tank. Since the guage you are describing is working exactly opposit to as intended, is it possible that an incorrect sender was installed, or, if there are 2 terminals on the guage, have the wires been switched so that the current is going through the wrong way?
Will not go faster than 20 mph
want to know if u have any codes first comon is throttle body if it said power loss on cluster unplug battery and re connect and drive .need toknow the codes thoug
Hi what this warning mins ( trans hot idle engine)
It means that the transmission oil is overheating and you need to cool the oil by allowing the engine to idle for a period of time . The transmission oil cooler is in the radiator and that means that the engine temperature will also be running hot . Check oil level in transmission and adjust to correct level. Check the load being carried /towed as this makes the transmission torque converter work harder and the speed you are travelling at What ever the reason I suggest that you run the fault codes to check for transmission problems
Hi I have 2000 yukon 4x4 5.3 and I have a warning
hahaha i have to laugh on this contact your auto parts store. who ever told you this dont know what they are talking about, i have found many so called obsolete parts and yours is only turning 15 ... i have found parts for an 88 with no problems. auto parts store they can find what you are looking for or order it.
Trans hot idle engine) 2000 yukon 4x4 5.3 what tha
Your question is unclear and it is not possible to fully understand what you are trying to describe.
Please re-state your question, providing greater detail as to what sort of problem you are experiencing.
Service 4wd light on
Check for loose damaged or out of adjustment shift linkage. Check for bent or binding and if vehicle has been driven on paved road in 4WD for a long time the driveline torque can make shifting difficult.
Not finding what you are looking for?